Advertisement
Quick Links
Option 1
After completion, the OPITEC factory packs are not toys that are generally commercially avai-
lable, but teaching and learning materials to support educational work. This kit may only
be built and operated by children and young people under the guidance and supervision of
knowledgeable adults. Not suitable for children under 36 months. Danger of suffocation!
parts list
Aluminium U-profile
Wooden strip
acrylic glass
Rainbow LED
slide switch
Resistance (grey-brown-grey-gold)
Battery clip 9V
1
Rainbow Disco Light
Option 2
Option 3
Please note:
quantity
1
1
1
2
1
1
1
Additionally required material: 9V block battery (e.g. 214545).
See also notes on page 5 of these instructions!
100,641
Tools Needed:
Sandpaper fine
wire stripper
Steel wool fine
pencil
Dimensions (mm)
70x65x25x2.5
250x20x5
100x65x12
5mm
19x6
180 Ohm
Ø5mm
Soldering iron
metal drill
(optional)
hot glue gun
Double sided adhesive tape
jigsaw
side cutter
grains
countersink
Description
U-profile
Wooden strip
acrylic glass
LED
switch
resistance
battery clip
Part no.
1
2
3
4
5
6
7
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Opitec 100.641
Summary of Contents for Opitec 100.641
- Page 1 Please note: After completion, the OPITEC factory packs are not toys that are generally commercially avai- lable, but teaching and learning materials to support educational work. This kit may only be built and operated by children and young people under the guidance and supervision of knowledgeable adults.
- Page 2 Assembly instructions 100.641 Rainbow Disco Light Options 1 & 2 Option 3 Saw the wooden strip (2) according to template 1. If desired, saw out a Transfer template 2 to the aluminum profile (1) depending on the desired variant, mark the holes, drill through with a 5mm metal drill and then deburr with a countersink.
- Page 3 Assembly instructions 100.641 Rainbow Disco Light Insert both LEDs (4) from the inside through the holes and align them: Bend the LED legs carefully (and not too close to the housing) as short legs (cathode K; negative pole) to the left. Then fix them in place shown in the picture and, if the connections are to be soldered, with a drop of hot glue.
- Page 4 Assembly instructions 100.641 Rainbow Disco Light Connect the free leg of the other LED to the resistor (6). Connect the red wire to the other leg of the resistor and the middle terminal of the switch. The free end (red cable) of the battery clip is connected to an external Connect the battery and test it.
- Page 5 Assembly instructions 100.641 Rainbow Disco Light 1. Factual information 1.1 Structure of the LEDs For some time now, there have been colored LEDs that flash alternately in different colors and have the necessary electronic circuitry housed in a housing. In our case, three colored LEDs are built into each housing, namely red, green and blue (RGB). All of the colors of the rainbow can be created using these three primary colors.
- Page 7 Stencil 100.641 1 : 1 Option 3 Options 1 & 2 Option 2 Option 3...
Need help?
Do you have a question about the 100.641 and is the answer not in the manual?
Questions and answers