Page 1
Please Note The Opitec Range of projects is not intended as play toys for young children. They are teaching aids for young people learning the skills of craft, design and technolo- gy. These projects should only be undertaken and operated with the guidance of a fully qualified adult.
Page 2
Instruction 108.982 Rainbow Light Ball ø2 Then saw out the recess and drill through the holes (ø2). Transfer the recess and the holes to the plywood panel (1) according to the drawing. Transfer the dimensions as shown to the two wooden strips (2) and Glue the strip cuts (2a+2b) around the base plate as shown.
Page 3
Instruction 108.982 Rainbow Light Ball anode cathode Insert the LED (4) into the provided holes from above as shown. Pay Strip the black jumper wire (8 approx. 70mm) from both sides and attention to the anode and cathode! Kink the legs of the LED from solder or twist it to the cathode of the LED as shown.
Page 4
Instruction 108.982 Rainbow Light Ball Connect a flat battery as shown and place it in the frame. Note: This Attach the two blade receptacles (7) to the two cable ends. (soldering can be attached with double-sided adhesive tape or hot-melt adhesive.