Page 1
All purpose glue Centre finder Please note The OPITEC range of projects are not primarily intended as toys for young children. They are designed as a a teaching aid for Design Technology to encourage pupils in a range of practical skills. These projects should only be attempted with the help of a qualified adult.
Page 2
Instructions Step 1: Using the pattern (Page 5) mark out the holes and cut out for the switch on the blank CD (1) . Use a centre finder to draw a middle line ,the centrs of the holes and the cut out. Finally drill the holes as shown Note: Drill a 1mm dia pilot holes first!! To cut the hole for the micro switch (7) drill a 3mm hole in one corner and insert a fretsaw blade through the hole and saw ot rhe shape.
Page 3
Instructions black cable batte- Step 7: ry holder Solder the black cable of the battery holder (6) on the middle connector of the slide switch (7). Connect the red wire of the battery holder to the anode of the motor-sided LED. For this purpose, cathode anode cut the red cable, so that it can be soldered to the...
Page 5
INSTRUCTIONS Pattern for the drilled holes and cut out for the switch Scale 1:1 Pattern for the position of the battey holder (6) + Motor (8) Scale 1:1 Position Battery holder (6) Position Motor (8) E113864#2...