Page 1
Side cutters Pencil,ruler Soldering and solder Please Note The OPITEC range of projects is not intended as play toys for young children.They are teaching aids for young people learning the skills of Craft, Design and Technolo- gy.These projects should only be undertaken and tested with the guidance of a fully qualified adult.
Page 2
INSTRUCTIONS General The cable can be connected by twisting or soldering 1. Trace the patterns (Page 5) on to the plywood Side part (b) (1) and on to the wood strips (2) see diagram 1 2. Saw out all the parts with a fretsaw ( hand or Dia.
Page 3
INSTRUCTIONS Dia. 9 Dia.8 Dia. 10 9. On the lamp (3) bend up about ca. 10. Cut the metal casing with side cutters 11. Remove the insulation from the 50 mm fom the coiled metal casing. (Dia. 9) cables ca. 10mm, twist the wires Using pliers bend the casing back together and tin and insert it through the hole with...
Page 4
INSTRUCTIONS CUTTING PLAN M 1:2 D111655#1...
Page 5
BAUANLEITUNG Schablonen Grundplatte/Seitentieile M 1:1 Base a Sides b + c D111655#2...