Spring SPIRIT Manual page 22

5 Initial operation
Danger!
Observe the Installation site requirements described in chapter 5.1.
Caution!
Do not leave children unattended in the vicinity of the appliance.
Risk of burns or injury!
High temperatures are generated during operation of the appliance.
5.1 Installation site requirements
- Place the appliance on stable and flat surfaces only.
- Place the appliance on heat-resistant surfaces only and not near hobs, gas flames or other heat sources.
Ensure there is sufficient free space next to and above the appliance and provide adequate ventilation.
Do not place tablecloths, table mats or other not heat resistant objects under the appliance.
- Keep the appliance out of reach of children.
- Keep a safe distance from easy flammable materials such as napkins, tablecloths, etc.
- Ensure that the power cord does not have any contact to hot surfaces at the appliance or other hot surfaces
such as hot plates or hot liquids. Make sure it does not pass over sharp edges and is not kinked or bent.
- Also ensure that the power cord does not hang down from the table or worktop so that no one can trip over it
and cause the appliance to be pulled down.
5.2 Before the first use
- Read the instructions and safety instructions carefully before using the appliance.
- Remove all packing materials and make sure that all parts as in chapter 8 Scope of delivery are present and
in proper condition.
- Wipe the housing as well as the hotplate with a soft, if necessary, slightly moistened cloth only. Clean the grill
plate with warm water and a mild detergent only. Dry all parts off thoroughly afterwards.
- Place the grill plate on the appliance. Make sure that it is placed properly.
- Heat the empty appliance for approx. 10 minutes. The slight smoke and odour that will probably be produced
are completely harmless. This is a matter of protective oils that were applied during production. Ensure good
ventilation of the room during this period!
22