Congratulations on your purchase of Innova Control Unit! Power Controller ....................4 Control Unit to Heater ..................5 Innova Control Unit is developed to enhance your sauna bathing with a variety of different Contactor Unit ....................6 features. It can adjust temperature, humidity, ventilation and light option in your sauna.
Power Controller The heater is connected to the electrical Control Unit to Heater Connection Diagram The Power controller or the separate control network semi-stationarily with a H07RN-F panel must not be located inside the sauna rubber cable or its equivalent. The use of room or in places where temperature PVC-insulated cable as a connecting cable Fig.
Contactor Unit Follow the instructions that are supplied Sensor location with heaters mounted on the wall If the heater used is more than 15 kW, together with the contactor unit. Fig. 5 TEMPERATURE SENSOR WITH FUSE ON THE WALL an additional contactor is needed. The Air Vent Sensor 2 (Optional) contactor unit is linked to the main Power...
Technical Diagram For Built-in Controls, Jumper For Control Unit Main Switch Built-in Control 1 1 0 1 Models remove the interface Fig. 9 Maximum Session Time PCB to access the (hours) Session Time jumper. Adjust this jumper Make sure that pin header to change max.
Maximum Session Time The maximum heater on-time is set by the The Control Unit Main Switch jumpers on SCB1 in the power controller, The maximum sauna session time depends The control unit switch can be found on the top end on the purpose of the sauna.
Page 7
IEC/EN Min 20W, max Cabin Light 100W. Only 60335-2-53 resistive load or dimmable Rating 230V 1N~, Dimensions INNOVA S types (phase control compatible) light 100W AC1 User Interface (W) 180 x (H) bulb 105 x (D) 31 Dimmer optional...
Need help?
Do you have a question about the Innova and is the answer not in the manual?
Questions and answers