Table of Contents
Advertisement
G31-M4 BIOS Manual
SuperIO Configuration
Advanced
Configure ITE8718 Super IO Chipset
OnBoard Floppy Controller
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
Restore on AC Power Loss
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Onboard Floppy Controller
Select enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you installed another FDC or the system uses
no floppy drive, select disabled in this field.
Options:
Enabled (Default) / Disabled
Serial Port1 Address
Select an address and corresponding interrupt for the first and second serial ports.
Options:
3F8/IRQ4 (Default) / 2F8/IRQ3 / 3E8/IRQ4 / 2E8/IRQ3 /Disabled
Parallel Port Address
This item allows you to determine access onboard parallel port controller with which
I/O Address.
Options:
378 (Default) / 278 / 3BC / Disabled
Parallel Port Mode
This item allows you to determine how the parallel port should function.
Options:
Normal (Default)
EPP
ECP
ECP+EPP
BIOS SETUP UTILITY
[Enabled]
[3F8/IRQ4]
[378]
[Normal]
[IRQ7]
[Power Off]
Using Parallel port as Standard Printer Port.
Using Parallel Port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
9
Allows BIOS to Enable
or Disable Floppy
Controller.
Select Screen
Select Item
Change Option
+-
F1
General Help
Save and Exit
F10
Exit
ESC
Advertisement
Table of Contents
