Biostar G31-M7 OC - BIOS Manual

Bios manual
Hide thumbs Also See for G31-M7 OC - BIOS:

Advertisement

Quick Links

G31-M7 OC BIOS M anual
BIOS Setup .................................................................................................1
1 Main Menu...............................................................................................3
2 Advanced Menu.......................................................................................7
3 PCIPnP Menu........................................................................................18
4 Boot Menu..............................................................................................22
5 Chipset Menu.........................................................................................25
6 Performance Menu...............................................................................30
7 Exit Menu...............................................................................................32
i

Advertisement

Table of Contents
loading

Summary of Contents for Biostar G31-M7 OC - BIOS

  • Page 1 G31-M7 OC BIOS M anual BIOS Setup ....................1 1 Main Menu....................3 2 Advanced Menu..................7 3 PCIPnP Menu..................18 4 Boot Menu....................22 5 Chipset Menu..................25 6 Performance Menu................30 7 Exit Menu....................32...
  • Page 2: Bios Setup

    G31-M7 OC BIOS M anual BIOS Setup Introduction T he purpose of this manual is to describe the settings in the AMI BIOS Setup program on this motherboard. The Setup program allows users to modify the basic system configuration and save these settings to CMOS RAM. T he power of CMOS RAM is supplied by a battery so that it retains the Setup information when the power is turned off.
  • Page 3: Pci Bus Support

    G31-M7 OC BIOS M anual PCI Bus Support T his AMI BIOS also supports Version 2.3 of the Intel PCI (Peripheral Component Interconn ect) local bus speci fication. DRAM S upport DDR2 SDRAM (Double Data Rate II Synchronous DRAM) is supported. Supported CP Us T his AMI BIOS supports the Intel CPU.
  • Page 4: System Memory

    G31-M7 OC BIOS M anual 1 Main Menu Once you enter AMI BIOS Setup Utility, the Main Menu will appear on the screen providing an overview of the basic system inform ation. BIOS SETU P U TILITY Main Advan ced PCIPnP Boot Chipset...
  • Page 5: Ata/Ide Configuration

    G31-M7 OC BIOS M anual Floppy A Select the type of floppy disk drive installed in your system. Options: 360K, 5.25 in / 1.2M, 5.25 in / 720K, 3.5 in / 1.44M, 3.5 in / 2.88M, 3.5 in / None IDE Configuration T he BIOS will automatically detect the presence of ID E/SAT A devices.
  • Page 6 G31-M7 OC BIOS M anual SATA1/2/3/4 Dev ice; IDE Channel 1 Master/Slave BIOS SETU P U TILITY Main SATA1 Device Select the type of device connected Device to the system. Type [Aut o] LBA/Large Mode [Aut o] Block (Multi-S ector Transfer)[Aut o] PIO Mode [Aut o] DMA Mode...
  • Page 7: Hard Disk Write Protect

    G31-M7 OC BIOS M anual S.M.A.R.T Set the Smart Monitoring, Analysis, and Reporting T echnology. Options: Auto (Default) / Disabled / Enabled 32Bit Data Transfer Enable or disable 32-bit data transfer. Options: Enabled (Default) / Disabled Hard Disk Write Protect Disable or enable device write protection.
  • Page 8: Advanced Menu

    G31-M7 OC BIOS M anual 2 Advanced Menu T he Advanced Menu allows you to configu re the settings of CPU, Super I/O, Power Management, and other system devices. Notice Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
  • Page 9 G31-M7 OC BIOS M anual C1E Support C1E is “Enhanced Halt State” function, this f unction helps to save power and decrease heat by lowering CPU frequen cy while the processor is not working. Options: Enabled (Default) / Disabled Hardware Prefetcher T he processor has a hardw are prefetch er that automatically analy zes its requirements and prefetches dat a and instructions from the memory into the Level 2 cache that are likely to be required in the near future.
  • Page 10: Core Multi-Processing

    G31-M7 OC BIOS M anual PECI T his item allows you to control the PECI function for the processor which supports Platform Environment Control Interface for better therm al management. Options: Disabled (Default) / Enabled Core Multi-Processing T his item allows multi-processing fun ction for multi-core processors. Options: Enabled (Default) / Disabled Intel(R) SpeedStep(tm) Tech...
  • Page 11 G31-M7 OC BIOS M anual Onboard Floppy Controller Select enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you installed another FDC or the system uses no floppy drive, select disabled in this field. Options: Enabled (Default) / Disabled Serial Port1 Address...
  • Page 12: Restore On Ac Power Loss

    G31-M7 OC BIOS M anual Restore on AC Power Loss T his setting specifies how your system should behave after a power fail or interrupts occurs. By choosing Disabled will leave the computer in the power off state. Choosing Enabled will restore the system to the status before power failure or interrupt occurs.
  • Page 13: Smart Fan Configuration

    G31-M7 OC BIOS M anual Smart Fan Configuration BIOS SETU P U TILITY Advan ced Smart Fan Conf iguration When you choice [Auto] , please run the CPU Smart Fan [Dis abled] calibration to define Smart Fan Cali bration the Fan parameters for Control Mode Smart Fan control Fan Ctrl OFF( C)
  • Page 14: Power Configuration

    G31-M7 OC BIOS M anual Fan Ctrl Start Value When CPU/System temperature arriv es to the set value, the CPU/System fan will work under Smart Fan Function mode. 0~127 (℃) Options: Fan Ctrl Sensitive Increasing the value will raise the speed of CPU/System fan. Options: 1~127 Power Configuration...
  • Page 15 G31-M7 OC BIOS M anual ACPI APIC support T his item is used to enable or disable the motherboard's APIC (Advan ced Programmable Interrupt Controller). T he APIC provides multiprocessor support, more IRQs and faster interrupt handling. Options: Enabled (Default) / Disabled AMI OEMB table Set this value to allow the ACPI BIOS to add a pointer to an OEMB table in the Root System Description T able (RSD T ) table.
  • Page 16 G31-M7 OC BIOS M anual Resume On Ring T his item allows you control the wake on ring function. Options: Disabled (Default) / Enabled Resume On PME# When you select Enabled, a PME signal from PCI card returns the system to Full ON state.
  • Page 17: Usb Configuration

    G31-M7 OC BIOS M anual USB Configuration T his item shows the USB controller and using USB device information. BIOS SETU P U TILITY Advan ced USB Configurat ion Enables support for legacy USB. AUTO Module Version - 2.24.2-13.4 option disables legacy support if USB Devices En abled: no USB devices are...
  • Page 18 G31-M7 OC BIOS M anual USB Mass Storage Dev ice Configuration BIOS SETUP UTILITY Advanced USB Mass Storage Device Configuration Number of seconds POST waits for the USB Mass Storage Reset Delay [20 Sec] USB mass storage device after start Device # unit command.
  • Page 19: Pcipnp Menu

    G31-M7 OC BIOS M anual 3 PCIPnP Menu T his section describes con figuring the PCI bus system. PCI, or Personal Computer Interconn ect, is a system which allows I/O devices to operate at speeds nearing the speed o f the CPU itself uses when communicating with its own special components. Notice Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
  • Page 20: Pci Latency Timer

    G31-M7 OC BIOS M anual PCI Latency Timer T his item controls how long a PCI device can hold the PCI bus bef ore another takes over. T he longer the latency, the longer the PCI device can retain control of the bus before handing it over to another PCI device.
  • Page 21: Reserved Memory Size

    G31-M7 OC BIOS M anual IRQ3/4/5/7/9/10/11/14/15 T hese items will allow you to assign each system interrupt a type, depending on the type of device using the interrupt. T he option “Available” means the IRQ is going to assign automatically. Options: Available (Default) / Reserved DMA Channel 0/1/3/5/6/7...
  • Page 22 G31-M7 OC BIOS M anual SB PCIE Ports Configuration BIOS SETU P U TILITY PCIPnP PCIE Ports Con figuration Options PCIE Port 0 [Aut o] PCIE Port 1 [Aut o] Auto PCIE Port 2 [Aut o] Enabled PCIE Port 3 [Aut o] Disabled PCIE Port 4...
  • Page 23: Boot Device Priority

    G31-M7 OC BIOS M anual 4 Boot Menu T his menu allows you to setup the system boot options. BIOS SETU P U TILITY Main Advan ced PCIPnP Boot Chipset Performance Exit Boot Settings Specifies the Boot Device Priority sequence. >...
  • Page 24: Cd/Dvd Drives

    G31-M7 OC BIOS M anual CD/DV D Drives T he BIOS will attempt to arrange the CD/DVD drive boot sequence automatically. You can also change the booting sequence. The number of device items that appears on the screen depends on the number of devices installed in the system. Boot Settings Configuration BIOS SETU P U TILITY Boot...
  • Page 25 G31-M7 OC BIOS M anual Bootup Num-L ock Selects the NumLock State after the system switched on. Options: ON (Default) / OFF...
  • Page 26: Chipset Menu

    G31-M7 OC BIOS M anual 5 Chipset Menu T his submenu allows you to configure the speci fic features of the chipset installed on your system. T his chipset manage bus speeds and access to system memory resources, such as DRAM. It also coordinates communications with the PCI bus. Notice Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
  • Page 27: North Bridge Configuration

    G31-M7 OC BIOS M anual North Bridge Configuration BIOS SETU P U TILITY Chipset North Bridge C hipset Configuratio n ENABLE: Allow remapping of Memory Remap F eature [E nabled] overlapped PCI memory PCI MMIO All ocation: above the total Memory Hole [D isabled] physical memory.
  • Page 28: Video Function Configuration

    G31-M7 OC BIOS M anual PEG Port T his BIOS feature is a toggle that enables or disables the PCI Express port. Options: Auto (Default) / Disabled Video Function Configuration BIOS SETU P U TILITY Chipset Video Function Configuration Options DVMT Mode Sele ct [D VMT Mode] Fixed Mode...
  • Page 29: South Bridge Configuration

    G31-M7 OC BIOS M anual South Bridge Configuration BIOS SETU P U TILITY Chipset South Bridge C hipset Configuratio n Options USB Functions [8 USB Ports] Disabled USB 2.0 Contro ller [E nabled] 2 USB Ports Audio Controll er [A zalia] 4 USB Ports 6 USB Ports Onboard Lan Co ntrol...
  • Page 30 G31-M7 OC BIOS M anual Onboard Lan Control T his item allows you to enable or disable the Onboard LAN. Options: Enabled (Default) / Disabled Onboard Lan Boot Rom T his item allows you to select the Onboard LAN Boot ROM. Options: Disabled (Default) / Enabled MAC ID Information...
  • Page 31: Performance Menu

    G31-M7 OC BIOS M anual 6 Performance Menu T his submenu allows you to change voltage and clock of various devices. (Howev er, we suggest you to use the def ault setting. Changing the voltage and clock improperly may damage the device.) Notice Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
  • Page 32 G31-M7 OC BIOS M anual PCIE Frequency Setting T his item allows you to select the PCIE clock control Options: 100 (Default) / Min=100; Max=150 CPU Voltage T his item allows you to select CPU Voltage Control. Options: Default (Default) / +5% / +10% / +15% DRAM Frequency T his item allows you to control the Memory Clock.
  • Page 33: Save Changes And Exit

    G31-M7 OC BIOS M anual 7 Exit Menu T his menu allows you to load the optimal default settings, and save or discard the changes to the BIOS items. BIOS SETU P U TILITY Main Advan ced PCIPnP Boot Chipset Performance Exit Exit Options...
  • Page 34: Change Supervisor Password

    G31-M7 OC BIOS M anual Security T his sub-menu allows you to provide/revise supervisor and user password. BIOS SETU P U TILITY Exit Security Setti ngs Install or Change the password. Supervisor Pas sword :Not Installe d User Password :Not Installe d Change Supervi sor Password User Access Le vel [Ful l Access]...
  • Page 35 G31-M7 OC BIOS M anual Passw ord Check T his item is for setting the timing that checking password. Options: Setup (Default) / Always Boot Sector Virus Protection T his option allows you to choose the VIRUS Warning feature that is used to protect the IDE H ard Disk boot sector.

Table of Contents