HP A4500A - VMEbus Single Board Computer 744 Motherboard Manual page 29

Note This task is easier if you remove the side panel from your system rack. Re-fit the
panel after connecting your cables.
Racking the Modem Distribution Panel HP J2085 #101
2 Fix the MDP to the mounting panel by screws at top and bottom. There
are mounting holes in the MDP, and on the mounting panel.You will
need 2 screws metric size M4, 10mm long, for the MDP.
3 To connect cables, pull the device cables up through the cable-access
slots in the mounting panel and connect them to ports on the MDP. This
supports and protects your cable connections.
4 Fix the frame supplied with the HP J2084A mounting kit to the mounting
panel with the screws supplied. The front panel clips onto this frame.
4
23