Table of Contents
Advertisement
2) IDE1 / IDE2 (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to
one IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical
drive). If you wish to connect two IDE devices, please set the jumper on one IDE device as Master
and the other as Slave (for information on settings, please refer to the instructions located on the IDE
device). Before attaching the IDE cable, please take note of the foolproof groove in the IDE connector.
3) SATA1/SATA2 (Serial ATA Connector,)
Serial ATA can provide up to 150MB/s transfer rate. Please refer to the BIOS setting for the Serial
ATA and install the proper driver in order to work properly.
GA-7CN700ID Motherboard
40
39
2
1
IDE1
IDE2
Pin No.
1
2
7
1
3
4
5
6
7
- 12 -
Definition
GND
TXP
TXN
GND
RXN
RXP
GND
Advertisement
Table of Contents
