2. Contents All photographs and drawings within this manual are 3. Product Introduction supplied by Draper Tools to help illustrate correct Intended Use operation of the product. Specification Every effort has been made to ensure the information contained in this manual is accurate.
Any other application beyond the conditions supplying air at high pressure. established for use will be considered misuse. Draper Tools • NEVER point this product at any person or any object accepts no responsibility for improper use of this product.
Over inflation could result in product and protect against any additional conceivable explosion or personal injury. risks. • NEVER carry the compressor by the hose. • ONLY use accessories supplied by Draper Tools. 5. Explanation of Symbols Read the instruction manual USB C rechargeable battery Warning!
Before assembling the product, lay the contents out and check them against the parts shown below. If any part is damaged or missing, DO NOT attempt to use the product. Please contact the Draper Helpline; contact details can be found at the back of this manual. (A) 1 × Storage bag (B) 1 ×...
7. Preparation 2. Press and hold the POWER button (10) until the LED screen comes on. Important: Before preparing or adjusting this product, read Note: the screen will turn off automatically if no activity and understand all the safety instructions listed in this after 3 minutes.
Using the Compressor Note: To switch between Bar, PSI and KPA hold the MODE button for 3 seconds. Important: Always follow the manufacturer’s 2. When the air pressure reaches the preset value the recommendations for the pressure levels. For vehicles this compressor will automatically stop.
8.4 Using the Inflation Adaptors Use the adaptors for inflating footballs, beach balls, air beds and inflatable toys. Important: Always follow the manufacturer’s recommendations for the pressure levels for inflating the item. 1. Attach the plastic adaptor (E), metal needle (F) or brass (G) inflation adaptor to the threaded hose connector (C2), turn until secure.
9.2 Troubleshooting Problem Possible cause Remedy Compressor will not switch on or Battery low or exhausted Charge compressor for 2 hours or operate until fully charged. Compressor is overheating or Recommended cycle time is 10mins cycle time exceeding 10minutes. on and 15minutes off. Follow recommendation.
Should the tool develop a fault, return the complete tool to Draper Tools will endeavour to hold any spare parts, if your nearest distributor or contact Draper Tools directly. applicable, for seven years from the date that it sells the Contact information can be found at the back of this final matching stock item.
Need help?
Do you have a question about the 23630 and is the answer not in the manual?
Questions and answers