Draper DA25/169 Manual
Draper DA25/169 Manual

Draper DA25/169 Manual

230v direct drive oil free compressor
Hide thumbs Also See for DA25/169:

Advertisement

Quick Links

230V DIRECT DRIVE
OIL FREE
COMPRESSOR
24978
EN
Version 2
January 2025

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DA25/169 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Draper DA25/169

  • Page 1 Version 2 January 2025 230V DIRECT DRIVE OIL FREE COMPRESSOR 24978...
  • Page 2: Product Reference

    All photographs and drawings within this manual are document is part of the product; retain it for the life supplied by Draper Tools to help illustrate correct of the product, passing it on to subsequent holders. operation of the product.
  • Page 3: Table Of Contents

    2. Contents 1. Preface 1.1 Product Reference 1.2 Revisions 1.3  Understanding the Safety Content of This Manual 1.4 Copyright © Notice 2. Contents 3. Product Introduction 3.1 Intended Use 3.2 Specification 4. Health and Safety Information 4.1 General Health and Safety Precautions 4.2  Additional Safety Instructions for this Air Compressor 4.3 Connection to the Power Supply 4.4 Residual Risk...
  • Page 4: Product Introduction

    Read this manual in full before attempting to assemble, Any other application beyond the conditions established operate or maintain the product, and retain it for later use. for use will be considered misuse. Draper Tools accepts no responsibility for improper use of this product. 3.2 Specification Stock No.
  • Page 5: Health And Safety Information

    • Important: DO NOT use this product if it is damaged precautions to prevent the product from tipping over. or leaking in any way. Contact Draper Tools to discuss Take care during transportation to not cause damage repair and replacement options.
  • Page 6: Additional Safety Instructions For This Air Compressor

    4. Health and Safety Information 4.2 Additional Safety Instructions for this Working with Compressed Air Air Compressor • Compressed air can cause severe injury. − ALWAYS turn off and disconnect the air   Important: ALWAYS check local regulations regarding supply before making any adjustments to the pressure vessels before use.
  • Page 7: Connection To The Power Supply

    If the power supply cord is damaged, it must be replaced by Draper Tools, an authorised service agent or similarly qualified personnel in order to avoid a hazard. The damaged or incomplete plug, when cut from the cord, shall be disabled to prevent connection to a live electrical outlet.
  • Page 8: Identification And Unpacking

    5. Identification and Unpacking 5.1 Product Overview (11) (10) (12) (13) Motor Tank pressure gauge Transport handle Air outlet pressure gauge ON/OFF pressure switch button Tank drain valve Air regulator valve (10) Tank Air outlet quick connector (11) Air filter Safety valve (12) Wheels –...
  • Page 9: What's In The Box

    If any part is occurred during shipment. damaged or missing, do not attempt to use the product. Please contact the Draper Helpline; contact details can be found at the back of this manual. (12)
  • Page 10: Preparation Instructions

    6. Preparation Instructions Important: Before preparing or adjusting this product, Fitting the Air Filter read and understand all the safety instructions listed in (11) this manual. Ensure that the product is disconnected from mains power before making any adjustment. 6.1 Assembly and Installation Important: Ensure that all parts are installed and firmly secured before use.
  • Page 11: Operating Instructions

    7. Operating Instructions 7.2 Basic Operation Important: Before operating this product, read and understand all the safety instructions listed in this manual. Ensure that the product is fully assembled and (5.1) correctly prepared for use. 7.1 Initial Start Up Fig. 5  1. Connect the air line to the compressor by pulling back the collar (5.1) on the air line coupling (5) and insert the air line coupling.
  • Page 12: Draining Moisture From The Tank

    WARNING! Keep hands and other body parts agent: contact Draper Tools for support. away from the drain valve (9) area while draining the moisture from the tank as it may be ejected 7.5 Safety Valve...
  • Page 13: Maintenance And Troubleshooting

    • Clean the filter more frequently if the compressor is product inspected by an authorised service engineer; used in a dusty environment. contact Draper Tools for support. WARNING! NEVER use petrol or solvents to WARNING! DO NOT use the compressor if you...
  • Page 14: Troubleshooting

    Valve fault/defective. Replace or repair. but cannot run or DANGER! DO NOT disassemble with air in the tank. Motor Faulty. runs slowly. Contact Draper Tools for advice. Poor contacts. Check connections and circuit. Low voltage. Fuse blown/ Incorrect fuse size fitted.
  • Page 15 Air leaks (on machine or in Tighten or replace leaking components. outside system). Broken inlet valves. Replace component. Piston ring worn. Contact Draper Tools for advice. Compressor runs Defective pressure switch or Replace part. continuously and safety valve. Contact Draper Tools for advice.
  • Page 16: Spares, Returns And Disposal

    Draper Tools Product Helpline for details of your nearest authorised agent. Draper Tools will endeavour to hold any spare parts, if applicable, for seven years from the date that it sells the final matching stock item.
  • Page 17: Warranty

    This warranty period covers parts and labour for 12 months from the date of Your Draper Tools guarantee is not effective until you can purchase. Where tools have been hired out, the warranty produce, upon request, a dated receipt or invoice to period covers 90 days from the date of purchase.
  • Page 18: Explanation Of Symbols

    11. Explanation of Symbols Net weight Read the instruction manual Wear ear defenders and safety glasses Continuous A-weighted sound power level Do not incinerate or throw onto fire Wear protective gloves WEEE – Warning! Waste Electrical & Electronic Equipment Do not dispose of Waste Electrical & Electronic Equipment in with domestic rubbish Tank size European conformity...
  • Page 19 Notes – 19 –...
  • Page 20: Contact Details

    Product Helpline: +44 (0) 23 8049 4344 Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...

This manual is also suitable for:

24978

Table of Contents