WHEN REPLACEMENT PARTS ARE REQUIRED, BE SURE TO USE REPLACEMENT PARTS SPECIFIED BY THE MANUFACTURER. Proper service and repair is important to the safe, reliable operation of all Hisense Electric Co., Ltd Equipment. The service procedures recommended by Hisense and described in this Service Guide are effective methods of performing service operations.
LCD TV Service Manual not undertaken any such broad evaluation. Accordingly, a serviceman that uses a service procedure or tools, which are not recommended by Hisense, must first satisfy himself thoroughly that neither his safety nor the safe of the equipment will be jeopardized by the service method selected.
Page 5
Safety regulations require that after a repair the set must be returned in its original condition. In particular attention should be paid to the following points. -Note: The wire trees should be routed correctly and fixed with the mounted Hisense Confidential - 5 -...
Page 6
Confirm that the voltage has dropped to a safe level before disconnecting or connecting the connector. Hisense Confidential - 6 -...
• To prevent electric shock and breakage of PC board, start the servicing work at least 30 seconds after the main power has been turned off. Especially when installing and removing the power board, start servicing at least 2 minutes after the main power has Hisense Confidential - 7 -...
Page 8
• Do not stack the circuit boards. Failure to observe this precaution may result in problems resulting from scratches on the parts, the deformation of parts, and short-circuits due to residual electric charge. • Routing of the wires and fixing them in position must be done in accordance with Hisense Confidential - 8 -...
Page 9
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the set. Hisense Confidential - 9 -...
LCD TV Service Manual 2. Product Function Specifications 2.1 Product Function Hisense Confidential - 10 -...
Page 11
5 CH 7 Power indicatior 8 Remote sensing window 9 AC power socket 10 Power switch(standby) 11 Power switch(on/off) Note: The above figures are reference only, please refer to the actual units to determine the appearances. Hisense Confidential - 11 -...
LCD TV Service Manual 3. LCD Panel Spec LCD15W57CA: General Description : SN:1051642 General Features Hisense Confidential - 13 -...
Page 14
LCD TV Service Manual 3.2 LCD19W57CA: General Description: SN:1043774 Hisense Confidential - 14 -...
Page 15
V315B1-L01 is a 31.5” TFT Liquid Crystal Display module with 16-CCFL Backlight unit and a ch LVDS interface. This module supports 1366 x 768 WXGA format and can display 16.7M colors (8-bits colors).The inverter module for backlight is built-in. Hisense Confidential - 15 -...
LCD TV Service Manual 4. Chassis Layout and Overall Wiring Diagrams 4.1 Chassis Layout LCD15W57CA: Description Part No Type/Model PCB/ Model 116927 RSAG2.908.1294-2\ROH Main BD RSAG7.820.1499\VERB\ROH 1051600 JSY-150202A\ROH\JK Inverter BD outsourcing 117480 RSAG2.908.1168-7\ROH Keypad PCA RSAG7.820.1214\VER.A\ROH 117146 RSAG2.908.1169-1\ROH IR Board RSAG7.820.1526\VER.B\ROH...
Page 17
LCD TV Service Manual LCD19W57CA: Description Part No Type/Model PCB/ Model 116509 RSAG2.908.1294-1\ROH Main BD RSAG7.820.1264 1041467 JSI-190411B\ROH\JK Inverter BD outsourcing 114552 RSAG2.908.1168-2\ROH Keypad PCA 0RSAG7.820.1214\VER.A 114175 RSAG2.908.1169 IR Board RSAG7.820.1213\VER.A Hisense Confidential - 17 -...
Page 18
LCD TV Service Manual LCD32W57CA: Description Part No Type/Model PCB/ Model 116660 RSAG2.908.1295-2\ROH Main BD RSAG7.820.1269\VERC\ROH 112129 RSAG2.908.916-4\ROH Power BD RSAG7.820.848A\VER.H\ROH 117301 RSAG2.908.1088-1\ROH Keypad PCA RSAG7.820.1101\VER.B\ROH 116295 RSAG2.908.1260-2\ROH IR Board RSAG7.820.1337\VER.B\ROH Hisense Confidential - 18 -...
Buttons TJC10T-3Y-400\ROH Main BD CN2<--> Key BD XPK01 TJC10T-5Y-1000\ROH Main BD CN1<-->IR BD XPR01 Audio (input/output) TJC3H-4Y-650-900\ROH Main BD CN7<--> Speakers Inverter BD CN2、CN3、CN4、CN5<--> Back light power The Connectors on the panel Panel backlight port Hisense Confidential - 23 -...
Page 24
Main BD C0N8<-->Panel Buttons TJC10T-3Y-650\ROH Main BD XP2<--> Key BD XPK1 IR &Led TJC10T-5Y-400\ROH Main BD XP1<-->IR BD XPR01 Audio out put (R/L) TJC3H-4Y-800-600\ROH Main BD XP16<-->Speaker L/R Back light power HX-3006B550\ROH Power BD XP809<-->Panel Hisense Confidential - 24 -...
White Balance White Balance Auto Test R DRV Auto Calibration G DRV LOGO B DRV OSD Language R CUT Country G CUT Option B CUT Factory Init BRIGHT_H Test Pattern CONTRAST _H Version: BRIGHT_L CONTRAST_L Hisense Confidential - 25 -...
LCD TV Service Manual Test Pattern Version BLUE Version: Panel Type: FLASH : 5.2.2、Design Menu Design Menu Picture Mode Sound Mode Sound Settings Power Save PIP Option MOVESHARPNESS LipSync Hisense Confidential - 27 -...
VOLUME 0 VOLUME 1 VOLUME 20 VOLUME 40 VOLUME 100 TVPRE SCALER VOLUME SCALER 0 Note : The above “Factory/Service OSD Menu” are reference only, please refer to the actual units to determine the appearances. Hisense Confidential - 28 -...
The software is upgraded by a burning tool- ISP_TOOL4.0.9, which can burn the program file “*.bin ”to the main board of the unit 6.1 Get ready for upgrading 6.1.1 Install the ISP_TOOL4.0.9-------only for the first time update. 1 、 Port Setting: Choose “system”option from the “control panel” Hisense Confidential - 29 -...
Page 30
LCD TV Service Manual Click the “system” icon as the following Choose the “hardware” option from the dialog window Hisense Confidential - 30 -...
Page 31
LCD TV Service Manual Click“device management” icon as the following Choose the port (COM and LPT1) Choose the ECP print port (LPT1) Hisense Confidential - 31 -...
Page 32
LCD TV Service Manual Click the port of print (LPT1)as the following Choose “port setting”option as the following Hisense Confidential - 32 -...
Page 33
Find the folder where the ISP_TOOL4.0.9 lies in. 2、 There are three folders/files in this folder together. DLPORTIO.dll and FTD2XX.DLL must be in the same folder Double click the ISP_TOOL4.0.9 icon, and then a dialog window will show as below. Hisense Confidential - 33 -...
Page 34
Base Addr setting is 0x378 Draw on the front of “pin 1 switch UART/I2c” Speed setting is 99 As following Choose“SDA in”and setting “PIN” is “PIN10”。 Notes: Do not draw on the front of “Reverse High”。 As following Hisense Confidential - 34 -...
Page 35
As following Choose “SDA out”and setting “PIN” is “PIN4” Notes: Draw on the front of “Reverse High”。 As following。 Choose “SCL out”and setting “PIN” is “PIN2” Notes: Draw on the front of “Reverse High” As following Hisense Confidential - 35 -...
Page 36
LCD TV Service Manual After having finished all above, clicking the “Apply ”button to complete the configuration。 6.1.2 Hardware connecting You can update the software through a special tool (as following) Hisense Confidential - 36 -...
Page 37
LCD TV Service Manual Connect the Debug board to the TV use VGA interface, the other parallel port to the computer, just as the following。 Hisense Confidential - 37 -...
LCD TV Service Manual 6.2 Upgrading with the ISP_TOOL4.0.9 6.2.1 Double click the ISP_TOOL4.0.9 icon and a dialog window will show as following。 Click the“Read ”button。 Hisense Confidential - 38 -...
Page 39
LCD TV Service Manual Choose the update file from the folder。 Hisense Confidential - 39 -...
Page 40
LCD TV Service Manual The update file has been chosen successfully。 Click the“Auto”button and choose parameters as following。 Click the“Run”button Click the“connect”button,then show a dialog box as following。 Hisense Confidential - 40 -...
Page 41
LCD TV Service Manual If show above then click the“Run”button again and again,till show the following dialog window。 Hisense Confidential - 41 -...
Page 42
If the update is successful, enter Factory Init Menu and select “Clear Unprotectly” a. Press VOL+ button to clear the EEPROM data. b. When the “Clear Unprotectly ” button becomes white, turn off the power. c. Restart the TV. Hisense Confidential - 42 -...
Try new batteries Replace battery Replace RC Replace remote control Check IR receiver Change Led & IR board Replace Led & IR BD Change Led & IR cable Replace Led & IR cable Replace main board Hisense Confidential - 43 -...
LCD TV Service Manual 7.2 Troubleshooting for Function Key Buttons does not work Replace tact switch Check switches Replace Key BD Check key board Check Key BD cable Change Key BD cable Replace main board Hisense Confidential - 44 -...
Check/replace IR Only BD or Keypad one works Try Power on by Check signal RC and Button OSD? Source Neither Both works Work Replace Main Replace Main BD Power on Replace Panel Replace Power BD Hisense Confidential - 45 -...
LCD TV Service Manual 7.4 Troubleshooting for Audio No sound Reconnect Check connecter Replace speaker wire Check speaker wire Replace speaker set Check speaker set Replace main board Hisense Confidential - 46 -...
LCD TV Service Manual 7.5 Troubleshooting for TV/VGA/HDMI input No picture on the screen Check Signal Source Make sure signal source is available Reconnect Check connect Replace cable Check cable Replace main board Hisense Confidential - 47 -...
LCD TV Service Manual 7.6 Troubleshooting for YPbPr input No picture on the screen Check Source work or not Check Source Device Reconnect Check connect Check Wires (Green Blue, Red) Replace wires Replace main board Hisense Confidential - 48 -...
7.7 Troubleshooting for Video/S-Video/ SCART input No picture on the screen Check Source work or not Check Signal Source Reconnect Check connect Replace Cable/Wires Check Cable/ Wires Check SCART BD Replace SCART BD Replace main board Hisense Confidential - 49 -...
LCD TV Service Manual 8. Explode View and explode BOM List Explode BOM List : LCD15W57CA Part Name Qty. Code No. Remark Front cover RSAG8.074.577 Screw SJ2836-87 M3×6 Zincification Bracket RSAG8.038.1447 RSAG8.335.070 Key board unit RSAG2.908.1168-2 Lens led RSAG8.640.069 Screw SJ2825-87 ST3×12C...
Page 51
Power Board Unit JSI-190411BROHJK LCD Panel HT190WG1-101JK Front cover RSAG8.074.506 RSAG8.335.0732 Key board unit RSAG2.908.1168-2 Lens led RSAG8.640.062 IR Board Unit RSAG2.908.1169 Screw SJ2831-87 ST3×8C Zincification Speaker YDT37E-3W8R-F Screw SJ2838-87 ST4×16C.II Zincification Screw SJ2825-87 ST3×12C Black Hisense Confidential - 51 -...
Page 52
Scutcheon RSAG8.804.3234 Rating label RSAG8.807.3715 Back cover RSAG8.074.542 Black Terminal bracket RSAG8.081.382 Black Main board unit RSAG2.908.1295-2 Power board unit RSAG2.908.916-4 Screw SJ2825-87 ST3X10C Black IR Board Unit RSAG2.908.1260-2 Lens led RSAG8.640.065 LCD PANEL V315B1-L01\JK Hisense Confidential - 52 -...
Need help?
Do you have a question about the LCD15W57CA and is the answer not in the manual?
Questions and answers