Antenna And Transmission Safety Precautions; Standards - Motorola 8900 - Blackberry Curve Cell Phone OEM Car Charger Developer's Manual

Antenna and Transmission Safety Precautions

User Operation
The C24 module is normally supplied without an antenna, and is compliant with SAR
requirements provided the following conditions are observed.
Do not operate your unit when a person is within 8 inches (20 centimeters) of the antenna. A
person or object within 8 inches (20 centimeters) of the antenna could impair call quality and may
cause the phone to operate at a higher power level than necessary.
Important:
Important:
Antenna Installation
The antenna installation must provide a minimum separation distance of 20 cm from users
•
and nearby persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
The combined cable loss and antenna gain must not exceed +5.3 dBi (800 band). The
•
combined cable loss and antenna gain must not exceed +4.2 dBi and total system output must
not exceed 2.0W EIRP in the PCS (1900) band in order to comply with the EIRP limit of
24.232 (b). OEM installers must be provided with antenna installation instruction and
transmitter operating conditions for satisfying RF exposure compliance.
For system integrations requiring higher antenna gain, or position closer than 20 cm from the
•
body, SAR compliance testing of the completed product will be required. It is strongly
recommended that the system integrator seeks the advice of a suitably accredited test
laboratory to develop a test plan and carry out necessary testing.

Standards

Interoperability Specification for cdma2000 Air Interface, 3GPP2 C.S0044-A.
Signaling Conformance Test Specification for cdma2000 Spread Spectrum Systems - 3GPP2
C.S0031-0.
Signaling Conformance Tests for cdma2000® Spread Spectrum Systems, TIA/EIA-898
December 2001, Telecommunications Industry Association.
Recommended Minimum Performance Standards for cdma2000 Spread Spectrum Mobile
Stations - 3GPP2 C.S0011-C.
Recommended Minimum Performance Standards for cdma2000®1 Spread Spectrum Mobile
Stations, TIA-98-F, September 2005, Telecommunications Industry Association.
December 15, 2008
The unit must be installed in a manner that provides a minimum separation distance
of 20 cm or more between the antenna and persons and must not be co-located or
operate in conjunction with any other antenna or transmitter to satisfy FCC RF
exposure requirements for mobile transmitting devices.
To comply with the FCC RF exposure limits and satisfy the categorical exclusion
requirements for mobile transmitters, the requirements described in the following
section, "Antenna Installation"
C24 Module Hardware Description
, must be met.
Preface
ix