Oil Warning System; Engine Switch; Dc Protector - Yamaha EF2400iS - Inverter Generator Owner's Manual

AE00111

OIL WARNING SYSTEM

When the oil level falls below the lower level, the engine
stops automatically. Unless you refill with oil, the engine
will not start again.
NOTE:
If the engine stalls or does not start, turn the engine
switch to "ON" position and then pull the recoil starter.
If the oil warning light flickers for a few seconds, the
engine oil is insufficient. Add oil and restart.
AE00124

ENGINE SWITCH

700-121
The engine switch controls the ignition system.
1
Ignition circuit is switched on.
q
The engine can be started.
2
Ignition circuit is switched off.
The engine will not run.
w
AE00780
763-259

DC PROTECTOR

The DC protector turns off automatically when the load
exceeds the generator rated output.
cC
Reduce the load to the specified generator rated
output if the DC protector turns off. If it turns off
again, consult a Yamaha dealer.
763-260
NOTE:
Press to reset the DC protector.
1
w
2
q
AE01179
TWIN TECH
(TERMINAL FOR CONNECTING SPECIAL CABLES
763-238a
FOR PARALLEL RUNNING )
This is the terminal for connecting special cables for par-
allel running of two EF2400iS. The parallel running
requires two EF2400iS and the special cables. (The
rated output in parallel running is 3.6 kVA and the rated
current is 30.0 A.)
The handling, operation procedure and the notes on
usage are described in the PARALLEL RUNNING KIT
OWNER'S MANUAL included in the Parallel Running Kit.
763-263
Consult a Yamaha dealer for this Parallel Running Kit.
7
"ON"
5 "STOP"
I "ON"
3 "OFF"
– 9 –