CeoTronics CT-DECT Multi Operating Instructions Manual page 8

3. Commissioning and operation
CT-DECT Multi WireCom – Digital Interface Base
a.
If not connected yet, plug the 6-pole connector (figure 1/c) of the adapter cable into the 6-pole
socket (figure 1/d) of the CT-DECT Multi WireCom – Digital Interface Base.
Connect the CT-DECT Multi WireCom – Digital Interface Base with the jack plug (figure 1/a) to the
ring circuit of the WireCom system.
Now the CT-DECT Multi WireCom – Digital Interface Base is ready for operation, as power is sup-
plied by the ring circuit of the WireCom system. The status LED – figure 1/e – lights up green. The
CT-DECT Multi WireCom – Digital Interface Base has no ON/OFF switch.
 PLEASE NOTE
Protect the device against humidity.
b. Maximum 4 (four) CT-DECT Standard headsets
Put the headset on and adjust it for a secure and comfortable fit.
For commissioning and operation of the CT-DECT headset, please follow CeoTronics' special in-
struction manual.
 PLEASE NOTE
CT-DECT Standard headsets must be subscribed to the CT-DECT Multi WireCom – Digital
Interface Base. (see chapters 7...7.4).
Switch the CT-DECT headsets on.
This starts the automatic connection setup between CT-DECT headsets and the CT-DECT Multi
WireCom – Digital Interface Base unit, which could vary in time. After a few seconds a double beep
in the CT-DECT headsets signals successful synchronization of CT-DECT headsets and CT-DECT
Multi WireCom – Digital Interface Base unit. Once connection setup is completed, you hear a high
beep in the CT-DECT headsets. From this moment on CT-DECT headsets and CT-DECT Multi
WireCom – Digital Interface Base are ready for duplex communication within the working range be-
tween headsets and their base station.
c. Communication
After completion of the automatic connection setup, mobile users with CT-DECT headsets are able
to speak permanently with one another. Each user can speak via the microphone of his headset
and hear via his speaker what the other user is saying (duplex communication). For speaking the
headset microphone must be in switched-on condition. All users can hear announcements incom-
ing via WireCom system and CT-DECT Multi WireCom – Digital Interface Base.
A user who is connected to the WireCom system can always hear what mobile users with CT-
DECT headset are speaking and he is able to speak to them at any time.
4. Exceeding the range limit
In case of exceeding the range limit, the connection between CT-DECT headset and CT-DECT Multi
WireCom – Digital Interface Base unit is cut. As soon as the user of the CT-DECT headset is back with-
in range of the CT-DECT Multi WireCom – Digital Interface Base, connection is automatically reset.
First, a high double beep sounds in the CT-DECT headset followed by a high single beep, signalling
that the connection is again in place.
Safekeeping – storage
5.
After use, keep the cleaned devices in a clean and dry place at normal room temperature and at normal
relative air humidity.
dok1262-be-03-0517
8 / 16