Page 1
CT-DECT Multi Transmitter/Receiver Unit for Wireless Duplex Communication Operating Instructions...
Page 2
Removable cover for the battery compartment. e Fastening clip on the rear. f 26-pole multi-purpose jack for connection of CeoTronics accessories, e.g. for a second CT communication set, for battery charging, for programming the unit by the factory. If a communication set is connected to the 6-...
Before using CeoTronics products read completely the appropriate operating instructions. If in doubt, ask our technical staff. If repair work of any kind needs to be done to CeoTronics products, arrange for it to be performed only by the company CeoTronics or by a specialized workshop that is authorized by CeoTronics. In all other cases our warranty and liability for the product shall lapse.
Page 5
Do not leave CeoTronics products lying around loose in cars, e.g. on the parcel shelf. Stow these products in a suitable, safe place in the car so that they do not present a danger to you or to other occupants of the car, if emergency braking is effected.
Page 6
– CT-DECT Base – CT-DECT Standard NOTE The base unit and the standard unit(s) can also be used in conjunction with other CeoTronics DECT units and DECT systems. Notice the special CeoTronics operating instructions for these units and systems. Power supply and operating time Power is supplied by a 3.6 V/2300 mAh Li-Ion rechargeable battery in the battery compartment of the...
Page 7
Unit with Lightweight Headset The Lightweight Headset (for example see Fig. 4) is a particularly lightweight, foldable headset with one or optionally two speakers. It might be equipped as follows: adjustable headband (Fig. 4/a), noise cancelling microphone with windshield (f) and flexible goose neck (e), speaker on one side (b), connecting cable without or with PTT button (g) and plug (h) for connection to the unit.
Page 8
The on-air subscription is a procedure which has to be performed once only by the factory. It must be performed only in the case of an error or if another CT-DECT Multi will be used in the system. If this is not the case skip the sections 3..3.2.2 and start with section 4.
Commissioning and operation Connecting the headset or hand microphone a. Connect he communication set to the jack (Fig. 1/a) on the upper side of the unit. b. If a communication headset is used – Put on the headset and adjust it so that it fits comfortably and correctly.
Page 10
Connection release Press one of the three push-buttons in the middle of the push-button bank on the base unit. The base unit is disconnected from the standard unit. A high beep tone then sounds in the communication set of the base unit and of the standard unit. Three-party conference Below the designations standard unit 1 and standard unit 2 are used only for the purpose of better differentiation in the operating instructions.
Always switch off the unit before you start charging. For charging connect the charger to the multi- purpose jack located on the bottom of the unit. Notice the special CeoTronics Operating Instructions for the charger.
Maintenance Visual inspection Examine the units and in particular the cables and connectors regularly for signs of fractures, cracks and wear. Send defective devices to CeoTronics for repair. Cleaning WARNING When cleaning ensure that no moisture penetrates inside the unit. Do not use any solvents (e.g.