CeoTronics CT-DECT Multi Operating Instructions Manual page 3

1
CeoTronics Operating, Warning, and Safety Instructions
For the use of the device and for prevention of personal injury or property damage,
notice the national safety and accident prevention regulations and the following warn-
ing and safety instructions in this document.
 Before using CeoTronics products, read completely the appropriate operating instructions. If in
doubt, ask our technical staff.
 Keep this document for later use.
 Use CeoTronics products only without damage and abrasion.
 If repair work of any kind needs to be done to CeoTronics products, arrange for it to be performed
only by the company CeoTronics or by a specialized workshop that is authorized by CeoTronics. In
all other cases, our warranty and liability for the product shall lapse.
 Keep CeoTronics products out of the reach of children and any other persons who are not familiar
with the handling and operation thereof.
 CeoTronics products may only be used for the specific application envisaged.
 Safe operation requires clean devices. Ensure that the devices (microphones, connectors etc.) are
clean and in good condition at all times.
 Should equipment, supplied by CeoTronics, be definitely put out of service you may return it to Ceo-
Tronics. We ensure recycling and / or disposal of outdated equipment in compliance with the
applicable environment protection law.
Product damage!
 Do not immerse a CeoTronics product into water, unless expressly specified for this purpose.
 Connect CeoTronics accessories to a device or disconnect them from a device only after switching
the device off, unless otherwise described in the operating instructions.
 Let devices that are designed for outdoor use during use outdoors always closed (e.g. CT-DECT
Case) and close unused ports with appropriate cover – if available.
 Do not store CeoTronics products in the open air or in damp ambient conditions. At all times keep
them clean, dry and at normal air humidity. CeoTronics pro- ducts must not be stored in areas with a
temperature of over +80° C, e.g. in the summertime on the parcel shelf of a car. If not stated other-
wise, the following temperature ranges are acceptable for CeoTronics products: -10 to +55°C for op-
eration, -40 to +80° C for storage.
 Pay attention that no humidity could penetrate into the device during cleaning. Do not use solvents
(e.g. benzene, alcohol, etc.) for cleaning! Safe operation requires clean devices. Ensure that the de-
vices (microphones, connectors etc.) are clean and in good condition at all times.
Risk of injury by connection leads!
 When using CeoTronics products that are equipped with connection leads ensure that the leads do
not get caught up in operational machinery or wheels!
Risk of injury by speaker volume!
 Please, note that in some audio devices (e.g. radios) very loud signaling beeps could be present as
the radio is switched on. There are various types of devices generating a series of tones in different
loudness levels. It may be necessary to adjust the volumes of the tones separately. These tones
could damage your hearing if they are set too high. Therefore, adjust signaling beeps to a conven-
ient level as desired before starting to use CeoTronics accessories. Follow the instructions of the
audio device manufacturer's operating manual to adjust the signaling beeps.
 For safety reasons reception volumes in excess of 85 dB (A) are possible with a whole series of Ce-
oTronics products. However, these can be regulated by the user. After switching on the communica-
tion system, set the reception volume to approx. 1/2 the available loudness volume and then test the
speaker volume, e.g. by opening the squelch on the radio set.
 Do not set the volume any higher than is necessary. A very high volume setting can lead to dam-
aged hearing, particularly if it is continuous. For high volumes or noise levels, wear additional ear-
plugs. If in doubt, ask your safety officer or company doctor.
dok1262-be-03-0517
3 / 16