Subscribe to Our Youtube Channel
Related Manuals for Electrolux DC6-15WW
Summary of Contents for Electrolux DC6-15WW
- Page 1 Installation manual Drying Cabinet DC6-15WW D13+ 427001408/GB, IE Original instructions 2024.10.22...
-
Page 3: Table Of Contents
Contents Contents 1 Safety Precautions ..........................5 General safety information......................5 Symbols............................5 2 Warranty terms and exclusions......................6 3 Technical data.............................7 4 Installation kit ............................9 5 Recycling instruction for packaging.....................10 6 Installation ............................11 Placement ..........................11 Mechanical installation ......................11 Narrow spaces ........................12 7 Air flow .............................13 Function principle........................13 Evacuation system........................14... -
Page 5: Safety Precautions
Installation manual 1 Safety Precautions WARNING. This appliance is intended only for drying textiles washed in water. DO NOT MODIFY THIS APPLIANCE. Servicing shall be carried out only by authorized personnel. Only authorized spare parts shall be used. When performing service or replacing parts, the power must be disconnected. Stationary appliances not fitted with means for disconnection from the supply mains hav- ing a contact separation in all poles that provide full disconnection under overvoltage cate- gory III, means for disconnection must be incorporated in the fixed wiring in accordance... -
Page 6: Warranty Terms And Exclusions
Warranty will be applicable where the customer has used only genuine spare parts and has performed maintenance in accordance with Electrolux Professional user and maintenance documentation made available in paper or elec- tronic format. Electrolux Professional strongly recommends using Electrolux Professional approved cleaning, rinse and descaling agents to obtain optimal results and maintain product efficiency over time. -
Page 7: Technical Data
Installation manual 3 Technical data fig.W01225A Control panel Electrical connection for external fan Electrical connection Exhaust air connection Hangers 1200 1970 2035 1100 Exhaust air connection ⌀125 mm, maximum permitted pressure drop 70 Pa, which corresponds to a straight pipe with a length of approximately 23 m. - Page 8 Installation manual Capacity kg of laundry Drainage capacity g/min *) Electrical connection 400V 3N AC 50Hz Traditional threaded fuse Automatic fuse Motor 2 x 155 Heating element output 6 x 1000 Overheat protection Evacuated air volume Removable hangers pieces Net weight Sound pressure level A-weighted emission sound pressure level <...
-
Page 9: Installation Kit
Installation manual 4 Installation kit In a complete delivery the following parts shall be included: • Drying cabinet with the upper part of the cabinet mounted. • Installation kit. • Installation- and operating manuals. fig.W01226C User Manual / Installation Manual Screw T6S 8x75 Washer 8.4x17x1.6 Plug x 4... -
Page 10: Recycling Instruction For Packaging
Installation manual 5 Recycling instruction for packaging fig.X02715 Fig. Description Code Type Packaging film LDPE 4 Synthetics Plastic tape PET 1 Synthetics Cardboard protection bar on PAP 20 Paper Cardboard protective strip PAP 20 Paper corner Cardboard protective bar PAP 20 Paper Chassis protection FOR 50... -
Page 11: Installation
Installation manual 6 Installation Place the drying cabinet on its final position. The straps around the adjustable feet can be used to raise the drying cabinet. Level the drying cabinet with the adjustable feet. Make sure that the top edges of the doors are level with each other. 6.1 Placement The drying cabinet should be positioned so that there is plenty of room for working, both for the user and service personnel. -
Page 12: Narrow Spaces
Installation manual 6.3 Narrow spaces To facilitate transport, there are straps around the adjustable feet. The upper part of the drying cabinet can be disassembled to reduce the height. Removing the upper part will result in the left of the drying cabinet to have a height of 1785 mm.. Demount the top The top is fastened to the lower part of the drying cabinet with four screws. -
Page 13: Air Flow
Installation manual 7 Air flow 7.1 Function principle The cabinet works with negative pressure in the drying compartment. A m² 5 A m² fig.W01430 Air is drawn in through an air intake in the upper part of the cabinet and through the door slots of the cabinet by means of two fans. -
Page 14: Evacuation System
Installation manual 7.2 Evacuation system The exhaust air goes through four filters and further on to the exhaust evacuation. The drying cabinet shall be connected directly to the ventilation channel (not through pipes or hoses in between). The drying cabinet has an exhaust air flow of up to 250 cubic meters per hour. This air is taken from the room where the drying cabinet is situated. -
Page 15: Air Flow Inside The Cabinet
Installation manual 7.3 Air flow inside the cabinet The figure shows the air flow in the drying cabinet. Air is blown in on the left and right sides as well as through the hangers. fig.W01216A Air flow in the cabinet Air flow in the hangers... -
Page 16: Electrical Connection
Installation manual 8 Electrical connection The electrical installation may only be performed by qualified personnel. The drying cabinet must be connected to an all-pole circuit breaker. Electrical connections Heating alternative Main voltage Heating power Total power Recommended fuse Electric heated machines 400V 3N~ 10 / 13 auto fuse... -
Page 17: Language Settings
Installation manual 9 Language settings fig.X03743 Display Up- and down arrows that are used to scroll up and down through the menus on the display. Start- and stop button On/off button • Disconnect the power to the machine. • Press and hold the UP and DOWN buttons and connect the power to the machine. The display lights up and shows parameter "P 105"... -
Page 18: Function Check
Installation manual 10 Function check May only be performed by qualified personnel. A function check must be performed when the installation is finished and before the appliance can be used. Whenever a repair has been made, a function check must be performed before the appliance can be used again. •... -
Page 19: Disposal Information
Installation manual 11 Disposal information 11.1 Disposal of appliance at end of life Before disposing of the machine, make sure to carefully check its physical condition, and in particular any parts of the structure that can give or break during scrapping. The machine’s parts must be disposed of in a differentiated way, according to their different characteristics (e.g. - Page 20 Electrolux Professional AB 341 80 Ljungby, Sweden www.electroluxprofessional.com...
Need help?
Do you have a question about the DC6-15WW and is the answer not in the manual?
Questions and answers