Congratulations on your new PARK LITE Solar with an integrated speaker. With PARK LITE Solar in
the car, you don't have to remember setting the parking disc and hence avoid hefty parking fines.
The electronics in PARK LITE Solar register the car's movements and automatically set the parking disk
at the correct parking time and only end the parking mode when the car starts moving again.
Before using PARK LITE Solar, we recommend that you read the entire manual thoroughly. To ensure
correct installation of PARK LITE Solar, the instructions below should be followed:
Before installation
A: Activate the battery
Remove the plastic strip carefully and press the battery back into place if it comes loose. If the battery
falls out, insert it again with the + upwards (same side as the one written in the battery compartment). If
the battery is placed correctly, the "hours" flashes on the display.
(It may take some time for the display to flash).
B: Set the digital clock
(The clock in PARK LITE Solar automatically adjusts to both summer and winter time, but the function
may be deactivated manually if necessary, see C:)
Activate setting mode by pressing and holding button ❶ until "hours" start flashing.
When "timer" is flashing, press button ❷ repeatedly until the timer is adjusted correctly.
Press button ❶ once after which "minutes" flashes on the display.
Adjust the minutes with button ❷.
Set the year, month, and date as above (in that order).
Choose how the parking start time should be handled.
2:PE The parking time is set to the nearest half hour. If you park at 13:07, the display will show 13:30.
This is a requirement, e.g., in Finland, Sweden, Germany, and Switzerland.
Need help?
Do you have a question about the PARK LITE and is the answer not in the manual?
Questions and answers