Table of Contents
Advertisement
Installation: Rear Facing
Rear Facing
LATCH Installation
•
Figure A illustrates a typical rear facing
LATCH installation.
Verify that your vehicle is equipped with
1
LATCH anchors.
•
If LATCH anchors are not installed, you
must use standard vehicle belt
installation methods.
2
If stored, remove LATCH connectors
from storage pouches under cover.
3
Press and hold the LATCH adjuster
release button, then pull to lengthen
LATCH harness to full length.
4
Fully recline the restraint and place it
sideways on the vehicle seat, with the
front facing toward you.
5
Verify that the LATCH harness is not
twisted, then attach the farthest
connector to LATCH anchor ( Fig. B ).
•
A positive click confirms attachment.
•
If LATCH connectors will not attach with a
positive click, it may be necessary to switch
the LATCH connectors as shown on page 21.
6
Rotate seat into rear facing position.
Verify that the LATCH harness is not
7
twisted, then attach the closest
connector to LATCH anchor ( Fig. C ).
•
A positive click confirms attachment.
10
A
B
C
8
Push the child restraint firmly into the
vehicle seat while pulling each LATCH
harness tight ( Fig. D ).
Verify that all connections are secure
9
and the restraint is stable.
•
Installation can be improved by the use of
®
the Versa-Tether
(see pages 23–25).
NOTE:
•
The back angle of the child restraint
should not exceed 45º when properly
installed in the rear facing position.
•
If there is a problem stabilizing the child restraint, place a rolled
towel in the crease of the vehicle seat to help level the child
restraint base.
WARNING:
Only raise restraint as described above. Do not raise the
restraint off of the front edge of vehicle seat; doing so will reduce
the protection for your child.
Removal:
Release each LATCH harness from the LATCH anchor by pressing the
release button on the LATCH connector. Disconnect Versa-Tether
attached.
•
When not in use, always store the LATCH connectors in pockets.
Installation: Rear Facing
D
®
, if
11
Advertisement
Table of Contents
