Care And Maintenance - Britax ROUNDABOUT - MANUAL 2 User Manual

Care and Maintenance

Child Seat Cover Removal
WARNING! Do not take apart the harness. Never remove
the buckle tongues from the harness. They cannot be reattached
after removal. If assembled incorrectly, the child seat may not
perform as intended.
1 Loosen the harness by pressing the harness
adjuster button while pulling the shoulder
straps forward as far as possible.
2 Unhook the shoulder straps from the
harness yoke on rear of child seat (Fig. A).
3 Pull the upper harness straps through the
shell and cover to the front of child seat.
4 Gently remove the upper portion of the
cover. Be careful not to damage the energy-
absorbing foam.
5 Remove the buckle and belly pad by turning
the metal buckle strap retainer of the buckle
on the underside of the child seat so the
short side will slide through the child seat
shell (Fig. B).
6 Push the retainer through the slots in the
shell and cover to the top of the child seat.
7 Pull the lower harness straps, buckle
tongues, and chest clip through lower slots
in cover.
8 Remove the entire cover from child seat.
For additional demonstration please visit www.BritaxUSA.com.
34
A
b
Refitting the Cover
To refit the cover, reverse the previous directions. Make sure the
shoulder straps are properly threaded through the chest clips and the
harness is not twisted.
Cleaning the Cover
• HAND WASH using cold water and mild soap.
• LINE or LIE-FLAT DRY to prevent cover from shrinking.
• DO NOT bleach, machine wash, machine dry, or iron the cover.
Cleaning the Shell
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT use solvents, abrasive cleaners, or disassemble the
harness.
Cleaning the Harness
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT bleach, machine wash, machine dry, iron or disassemble
the harness.
Care and Maintenance
35