Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for iRobot Roomba 205 DustCompactor
Summary of Contents for iRobot Roomba 205 DustCompactor
- Page 1 Roomba ® DustCompactor ™ Combo robot Owner's Guide...
- Page 2 WARNING: To prevent the risk of your robot falling down stairs, ensure that your dock is placed at least 5 feet (1.5 meters) away from stairs. For more information, visit global.irobot.com...
- Page 3 Plug in the dock Install the Edge Sweeping Brush Plug the power cord into the wall. Wrap the cord back so it won’t get in the way of Align the edge sweeping brush and press down until you hear a click. the robot as it comes and goes.
- Page 4 Your robot comes with a partial charge, but we recommend that you charge the robot for 4 hours prior to starting the Read enclosed safety information guide first before IMPORTANT: first cleaning. using your robot. For more information, visit global.irobot.com...
- Page 5 About your Roomba® 205 DustCompactor™ Robot Bottom View Top View Bin Release Button Bumper Carpet Sensor (combo Brush Cover Release Tab models only) Bin Lid Release Button ClearView™ LiDAR Brush Cover Charging Contacts Bin Port Edge Infrared Sensor Caster Wheel Cliff Sensors Arm Control Water Tank Release Button...
- Page 6 The DustCompactor™ Bin must be installed for both NOTE: The water tank may contain a small amount of residual water vacuuming mode and vacuuming & mopping mode otherwise the due to quality inspection. This is normal. vacuum-mop cannot be turned on. For more information, visit global.irobot.com...
- Page 7 Charging Charging during a cleaning Power Icon Indicator You robot will return to the dock whenever it needs to recharge. Once it is sufficiently charged, it will then resume cleaning where it left off. POWER Button Standby mode White - Fully charged and connected Flashing White - Return to dock to charge Your robot uses a small amount of power whenever it is on the dock.
- Page 8 We do not recommend using mopping functions on unsealed hardwood floors and certain laminate/ vinyl planks due to potential water damage to the flooring and/or subfloor. For more info, please visit global.irobot.com.. For more information, visit global.irobot.com...
- Page 9 Do not add liquids such as hot water, detergent, or disinfectant as they could damage the robot. Only use cold water or iRobot approved cleaning solution as shown on our support site at global.irobot.com. After completing your mopping and vacuum cleaning, make sure to Remove water tank and mop pad, by pressing the tank release buttons on empty the water tank and replace the mop pad.
- Page 10 If your robot needs water in the middle of a job, tap the button or press PAUSE in mobile app to pause. Remove tank, add water, and reinstall the tank. Press button or RESUME in app., to resume. For more information, visit global.irobot.com...
- Page 11 Inspect every 6 months Replace if worn or damaged * Replacement frequency may vary. Parts should be replaced if visible wear appears. If you think you need a replacement part, please contact iRobot Customer Care for more information. Roomba® 205 DustCompactor™ Owner’s Guide...
- Page 12 Reinstall the multi-surface brush and brush cover in the robot. NOTE: For instructions to perform a deeper cleaning of the multi-surface brush, see global.irobot.com IMPORTANT: It is recommended to replace the main brush every 6-12 months for an optimal cleaning effect. For more information, visit global.irobot.com...
- Page 13 Cleaning the Front Caster Wheel Cleaning the Charging Contacts and Sensors Unplug dock from wall and wipe charging contacts and sensors with a clean, dry cloth or lightly dampened Pull the caster wheel upwards to remove. melamine foam. CHARGING CONTACTS SENSORS Remove hair and debris from the front caster wheel and the caster wheel cavity.
- Page 14 Remove the filter by pinching the tab and Remove debris by tapping the filter against your Wipe the Bin with clean cloth. pulling the filter out. trash container. For more information, visit global.irobot.com...
- Page 15 Reinsert filter. Securely close bin by closing latch and Place bin back in robot. ensuring all sides are sealed IMPORTANT: Squeeze all gaps that may exist around perimeter of lid. A proper seal on the bin is required for optimal operation. Roomba®...
- Page 16 Soap can damage the robot during operation NOTE: After mopping, immediately remove the water tank, empty out any remaining water, and clean and dry the mop pad to prevent lingering odor and mildew. For more information, visit global.irobot.com...
- Page 17 IR window Clean once a month * Replacement frequency may vary. Parts should be replaced if visible wear appears. If you think you need a replacement part, please contact iRobot Customer Care for more information. IMPORTANT: Do not spray cleaning solution or water onto the sensors or sensor openings.
- Page 18 button for 10 seconds. Press the bumper in for 10 seconds while holding the button. All indicators will then turn off. • Package the robot securely for shipping. If you need further assistance, please visit your Roomba® Home app, contact our Customer Care team or visit global.irobot.com. For more information, visit global.irobot.com...
- Page 19 Need further assistance? We’re here to help. Download the Roomba® Home App or visit global.irobot.com for product support or to iRobot USA Customer Care Hours contact your local support center. If you need further assitance in the US & Canada, call the Monday to Friday, 9AM —...
- Page 20 ©2025 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved. iRobot, Roomba, DustCompactor and Roomba Combo are registered trademarks of iRobot Corporation. Wi-Fi and the Wi-Fi logo are registered trademarks of Wi-Fi Alliance. Apple and App Store are trademarks of Apple Inc., registered in the U.S. and other countries. Google Play is a trademark of Google LLC.
Need help?
Do you have a question about the Roomba 205 DustCompactor and is the answer not in the manual?
Questions and answers