How To Use Your Unit; Before Starting Break-In Procedure; Before Each Start-Up - Delta ShopMaster A05581 Instruction Manual

Motor Overload Protector (not shown): The motor has an automatic reset
thermal overload protector. If the motor overheats for any reason, the overload
protector will shut off the motor. The motor must be allowed to cool down
before restarting. The compressor will automatically restart after the motor
cools.
the "AUTO/ON" position.

How to Use Your Unit

How to Stop:
1. Set the Auto/On/Off switch to "OFF".
Before Starting
Break-in Procedure
This procedure is required before the air compressor is put into service and
when the check valve or a complete compressor pump has been replaced.
1. Make sure the Auto/On/Off switch is in the "OFF" position.
2. Plug the power cord into the correct branch circuit receptacle. (Refer to
Voltage and Circuit Protection paragraph in the Installation section of this
manual.)
3. Open the drain valve fully (counterclockwise) to permit air to escape and
prevent air pressure build up in the air tank during the break-in period.
4. Set the Auto/On/Off switch to "AUTO/ON" position. The compressor will
start.
5. Run the compressor for 5 minutes. Make sure the drain valve is open and
there is minimal air pressure build-up in tank.
6. After 5 minutes, close the drain valve (clockwise). The air receiver will fill to
"cut-out" pressure and the motor will stop.
The compressor is now ready for use.

Before Each Start-Up:

1. Set Auto/On/Off switch to "OFF".
2. Turn regulator knob counterclockwise until it stops.
3. Attach hose and accessories.
rating for air tools and accessories. The regulator outlet pressure must
never exceed the maximum pressure rating.
A05581
The motor will automatically restart without warning if
plugged in electrical outlet and "Auto/On/Off" switch is in
Serious damage may result if the following break-in
instructions are not closely followed.
Too much air pressure causes a hazardous risk of
bursting. Check the manufacturer's maximum pressure
12- ENG