Operating Your Breville Ikon™ Quiet Boil Kettle; Before First Use - Breville BKE570 - V C10 Instructions Manual

operating your Breville ikon™ Quiet Boil Kettle

Before first use

Remove any promotional material attached to
your kettle. It is recommended that before first
use the kettle is filled to the maximum level,
boiled and water discarded. Your kettle will only
operate when positioned on the power base
with the On/Off switch in the 'On' position. The
kettle will automatically switch off once the
water has boiled.
operation of your kettle
1. To fill the kettle, remove it from the power
base and open the lid by pressing the lid
release button. Fill with the desired amount
of water. Always fill the kettle between
the minimum and maximum marks on the
water window. Too little water will result in
the kettle switching off before the water has
boiled.
2. Ensure that the lid is locked firmly into
place. Place the kettle firmly onto the power
base. Power plug the power cord into
230/240V power point and switch 'On'.
3. Press the On/Off switch to the 'On' position.
The power 'On' light and the water gauge
will illuminate.
always fill the kettle between the minimum
(min) and the maximum (max) marks on the
exterior of the kettle. Too little water will result
in the kettle switching "off" before the water
has boiled. f illing above the maximum mark on
the exterior of the kettle may result in boiling
water splashing from the kettle.
ThIs appl Ian Ce Is des Igned for The BoIl Ing of dr InKIng Qual ITy w aTer onl y, never
use IT To hea T or BoIl any o Ther l IQuIds or foods Tuffs. The l Id should al ways Be
f Irml y In pla Ce and lo CKed Closed Before use.
This kettle must only be used with the power
base supplied. use caution when pouring water
from your kettle, as boiling water will scald. do
not pour the water too quickly.
The kettle will automatically switch 'Off' once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
The kettle may be stored on its power base
when not in use. The power point should be
switched off and the appliance power plug
unpower plugged from the power when not in
use.
safety boil dry protection
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water. If
this occurs the kettle will stop heating. Switch
'Off' at the power point and allow kettle to
cool before refilling. The safety device will
automatically reset when the kettle has cooled
down.
For additional safety your kettle is fitted with
an additional thermal cut out. In the event of
overheating, the kettle will automatically shut
down to prevent further damage. Should this
occur, take your kettle to an authorised Breville
Service Centre.
7