Advertisement
Operating your Breville Ikon Cordfree Kettle
Before first use
Remove any promotional material attached to your
kettle. It is recommended that before the first use the
kettle is filled to the maximum level, boiled and
water discarded. Your kettle will only operate when
positioned on the power base with the On/Off switch
in the On position. The kettle will automatically
switch off once the water has boiled.
Operation of your kettle
1. To fill the kettle, remove it from the power
base and open the lid by pressing the lid release
button. Fill with the desired amount of water.
Always fill the kettle between the minimum and
maximum marks on the water window. Too little
water will result in the kettle switching off before
the water has boiled.
2. Ensure that the lid is locked firmly into place.
Place the kettle firmly onto the power base. Plug
the power cord into 230/240V power point and
switch 'On'.
3. Press the On/Off switch to the 'On' position.
The power 'On' light and the water guage
will illuminate.
Always fill the kettle between the minimum
(Min) and the maximum (Max) marks on the
exterior of the kettle. Too little water will result
in the kettle switching "Off" before the water
has boiled. Filling above the maximum mark on
the exterior of the kettle may result in boiling
water splashing from the kettle.
That's the idea™
THIS APPLIANCE IS DESIGNED FOR THE BOILING OF DRINKING QUALITY WATER ONLY, NEVER
USE IT TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID SHOULD ALWAYS BE
FIRMLY IN PLACE AND LOCKED CLOSED BEFORE USE.
6
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do
not pour the water too quickly.
That's the idea™
The kettle will automatically switch 'Off' once the
water has boiled. Lift the kettle from the power base
and pour the water. Take care to hold the kettle level,
especially when filled to the maximum level. To
re-boil it may be necessary to wait for a few seconds
to allow the control to reset.
The kettle may be stored on its power base when not
in use. The power point should be switched off and
the appliance plug unplugged from the power when
not in use.
Safety Boil Dry Protection
The kettle is fitted with a safety device, which
protects against overheating should the appliance be
operated with insufficient water. If this occurs the
kettle will stop heating. Switch 'Off' at the power
point and allow kettle to cool before refilling. The
safety device will automatically reset when the kettle
has cooled down.
For additional safety your kettle is fitted with an
additional thermal cut out. In the event of
overheating, the kettle will automatically shut down
to prevent further damage. Should this occur, take
your kettle to an authorised Breville Service Centre.
Care and Cleaning
Always switch off at the power outlet, and
then unplug the appliance from the power
outlet before cleaning.
Removable filter
The Ikon Cordfree kettle features a removable mesh
filter to filter out scale deposits for cleaner water. To
remove the scale deposits remove the filter by
opening the lid and lifting up and out of the kettle.
The filter can be cleaned by running under hot water
and rubbing with a cleaning cloth or brush.
To replace filter, simply slide the filter down into the
slot behind the spout of the kettle.
Removal of mineral deposits
Mineral deposits in tap water may cause the
kettle interior and water gauge to discolour over
time. This may be removed by using a proprietary
kettle descaler which is available from most
leading supermarkets, department stores and
hardware stores.
Alternatively:
2
1. Fill the kettle until
⁄
full with 1 part
3
vinegar and 2 parts water. Boil and allow
to stand overnight.
2. Empty the solution from the kettle. Fill the
kettle with clean water, bring to boil and
discard the water. Repeat and the kettle will
be ready for use.
NEVER IMMERSE THE KETTLE BASE, SWITCH AREA, POWER BASE OR POWER SUPPLY CORD IN
WATER, OR ALLOW MOISTURE TO COME IN CONTACT WITH THESE PARTS.
To clean the exterior
The outside of the kettle may be wiped over with a
damp cloth and polished with a soft dry cloth.
Do not use chemical, steel wool, or abrasive
cleaners to clean the outside of the kettle.
That's the idea™
7
Advertisement
