TP-Link Archer NX200 User Manual page 21

Chapter 4
• Authentication Type
it with your ISP or keep the default value.
NONE - No any authentication is needed.
PAP - Password Authentication Protocol. This protocol allows the device to establish
authentication with the peer using two handshakes. Select this option if the ISP requires
this authentication type.
CHAP - Challenge Handshake Authentication Protocol. This protocol allows the device
to establish authentication with the peer using three handshakes and checking the
peer identity periodically. Select this option if the ISP requires this authentication type.
PAP/CHAP - Password Authentication Protocol/Challenge Handshake Authentication
Protocol. This protocol allows the device to establish authentiation with the peer using
two or three handshakes. Select this option if the ISP requires this authentication type.
¾ Dial-up Internet access via EWAN:
Follow the steps below to check or modify your internet connection settings.
1. Visit http://tplinkmodem.net
the password you set for the router.
2. Go to Basic > Internet
3. Follow the instructions on the page to continue the configuration. Parameters on the
figures are just used for demonstration.
Note:
Since different connection types require different cables and connection information, you can also refer to the
demonstrations to determine your connection type.
1 ) If you choose
automatically by the ISP. Dynamic IP users are usually equipped with a cable TV
or fiber cable.
2 ) If you choose
corresponding fields.
- Some ISPs need a specific authentication type, please confirm
or http://192.168.1.1, and log in with your TP-Link ID or
page and select EWAN.
Dynamic IP, the IP address and Subnet Mask are assigned
Static IP, enter the information provided by your ISP in the
Set Up Internet Connection
17