TP-Link Archer NX200 User Manual page 20

Chapter 4
4 3 Manually Set Up Your Internet Connection
In this part, you can check your current internet connection settings. You can also
modify the settings according to the service information provided by your ISP.
¾ Dial-up Internet access via Mobile WAN:
1. Visit http://tplinkmodem.net
the password you set for the router.
2. Go to Basic > Internet
default value. If your ISP settings are not detected by the router, you can create an
internet connection in
3. Configure Dial-up settings.
• Mobile Data - It is enabled by default. You can disable it to prohibit Internet access.
• Network Mode - The device supports three modes of network connection - 5G/4G/3G
, 5G Only, 4G/3G, 4G Only, and 3G. You can select network mode according to your
mobile network standard and the current network condition.
• Profile Name - The name of the profile you've selected.
• PDP Type - Select the type of your PDP (Packet Data Protocol).
• APN - Access Point Name, provided by your ISP. You need to set APN only after
selecting the static APN type. You are recommended to keep the default value.
• Username/Password
fields are case-sensitive. You are recommended to keep the default value.
or http://192.168.1.1, and log in with your TP-Link ID or
page and select MBB. You are recommended to keep the
Advanced > Network
- Enter the username and password provided by your ISP. These
Set Up Internet Connection
> Mobile WAN.
16