Hand Held Remote Controller - McIntosh MA6400 Owner's Manual

cable with 1/8 inch mini phone plugs on each end. Connections are to the Tip (+) and Sleeve
MA6400
(-) of the plug.)
HAND HELD
REMOTE
tuner preset memory. Press REVIEW again to stop on the desired preset. Cancel the automatic
CONTROLLER
REVIEW process by pressing REVIEW a second time, or pressing any other Tuner function
pushbutton.
10. Press SPKR 1 or SPKR 2 to select either pair of loudspeakers or both pairs simultaneously.
11. E (ENTER) is used with the optional RCT-2 Remote Control Translator to operate accessory
equipment.
12. Press MUTE to mute SPEAKERS 1 and 2 and the MAIN OUTPUTS. MUTE does not affect
TAPE 1 and 2 OUTPUTS or HEADPHONES. A Red LED to the right of the front panel volume
control turns ON to indicate that the outputs are muted. Press MUTE a second time, press UP
or DOWN VOLUME, or press another input pushbutton to restore normal operation.
13. Press UP (
listening volume. The TAPE 1 and 2 OUTPUTS are not affected by the remote VOLUME
pushbuttons
HOW TO INSTALL BATTERIES IN THE
MA6400 HAND HELD REMOTE CONTROLLER
making sure to observe the battery polarities indicated in the battery compartment.
decreases, and MAY even fail to operate. In this case, replace both batteries with fresh ones.
NOTE:
1. Do not mix old and new batteries. Use ONLY batteries that are new.
2. Make sure both batteries are of the same type and identical.
3. To prevent damage caused by possible battery leakage, remove the batteries from the
4. Never dismantle batteries or dispose of them in a fire, as they may explode. Dispose of old
12
Press REVIEW to start the automatic 3 second audition of each of the stations stored in the
) or SEEK DOWN (
SEEK UP (
) VOLUME to raise the listening volume and DOWN (
Slide open the battery compartment. Insert two type AAA batteries into the compartment,
When the batteries are nearing exhaustion, the effective range of the remote controller
remote controller if it is not going to be used for an extended period of time.
batteries in an approved method for proper safety.
) cycles tuning through all station frequencies.
) VOLUME to lower the