Cable Adapter Module; Attaching And Removing - Symbol MC9090G User Manual

Cable Adapter Module

This section describes how to set up and use the snap-on CAM with the mobile computer. The CAM snaps on to
the bottom of the mobile computer and can be easily removed when not in use.
Latches
Communications Port
Cable Adapter Module
Figure 6-14
CAUTION
When attached to the mobile computer, the CAM can perform the following functions.
•
Provides power for operating the mobile computer, with the appropriate power connection.
NOTE When a mobile computer with Windows Mobile 5.0 is connected to a host computer through the CAM and an
ActiveSync connection is made, the WLAN and WWAN radios (if applicable) are disabled. This is a Microsoft
security feature to prevent connection to two networks at the same time.
•
Provides serial connection through the serial pass-through port for communication with a serial device, such
as a host computer.
•
Provides USB connection through the USB pass-through port for communication with a USB device, such as
a host computer.
•
Charges the mobile computer's battery, when used with the appropriate power supply.

Attaching and Removing

To attach, snap the CAM onto the bottom of the mobile computer.
Pogo Pin Pass-through
Connector
Latch Grip
Power Port
Use only a Symbol approved power supply output rated 12 VDC and minimum 3.3 A. Use of an alternative
power supply will void the product warranty and may cause product damage. See
for the power supply regulatory compliance statement.
Accessories 6 - 15
Appendix C, Regulatory