Lancom AirLancer I-360D-5G Mounting Instructions page 4

Mounting Instructions LANCOM AirLancer I-360D-5G
Important infoirmation
Working responsibly with high frequencies
For compliance with protection requirements of the EU directive 2014/53 and EN 62479 in
relation to the basic limits for human safety in electromagnetic fields and the "FCC Policy on
Human Exposure to Radiofrequency Electromagnetic Fields", it is essential to configure the
accurate antenna gain value in the Wi-Fi router or Wi-Fi access point.
Electrical and electronic equipment law
In the interests of recycling, please do not dispose of electrical and electronic waste in
your household garbage. Ensure that your electrical and electronic waste is disposed of in
accordance with the regulations in your country.
Proper handling of antenna cables
Antenna cables are sensitive RF cables. During installation it is important that the cables are not
creased, and bent as little as possible, otherwise the antenna will suffer a loss of performance.
Do not coil the antenna cable in tight loops.
Antenna gain and terminating unused antenna connectors on the access point
It is essential for unused antenna connectors on the access point to be terminated with
the supplied rod antenna. The terminating resistor supplied with the adapter AirLancer
AN-RPSMA-NJ is suitable for use with indoor access points. In addition, you must disable
the unused antenna connectors in LCOS (changing the antenna grouping of the respective
WLAN module), and configure the antenna gain of the antenna. The settings can be found in
LANconfig under: Configuration > Wireless LAN > General > Physical WLAN settings > Radio