Battery Information; Installing Batteries - McIntosh C220 - REMOTE CONTROL Programming Manual

Introduction
The McIntosh HR070 Series Remote Controls
(HR070, HR071, HR072 and HR073) supplied with
McIntosh Preamplifiers, Integrated Amplifiers, A/V
Control Centers, and Source Components not only
control a McIntosh Component System, but also have
the ability of controlling non McIntosh Components in
your system. Refer to figures 1 through 4
The HR70 Series Remote Controls have stored
in permanent memory the necessary information to
send the correct commands to the component to be
controlled. By entering a five digit numeric code the
commands for controlling the component is activated.
In the event the Remote Control doesn' t have the
code to control a particular component, the Remote
Control has the ability to learn and store the IR Sig-
nals sent out by the Remote Control originally sup-
plied with the component.

Battery Information

Use only fresh batteries of the required size and
recommended type. When the battery voltage is low,
the Push-button will blink 5 times after another
Push-button on the Remote Control is pressed. Do not
mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable
batteries of different capacities.
If the Remote Control will not be used for an
extended period, remove the batteries. They
can leak chemicals and destroy the Remote
Control.
When discarding the Remote Control,
comply with local rules or regulations. Bat-
teries should never be thrown away or incin-
erated but disposed of in accordance with the
local regulations concerning battery disposal.
For additional information please visit the McIn-
tosh Web Site at www.mcintoshlabs.com.
2

Installing Batteries

1. Open the battery compartment cover (located on
the back of the remote).
2. Place the AA batteries in the compartment and
match the + and - polarity symbols inside.
3. Replace the cover.
Figure 1