McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.com HR070 Series Remote Control Programming Guide...
2. Place the AA batteries in the compartment and Control Centers, and Source Components not only match the + and - polarity symbols inside. control a McIntosh Component System, but also have 3. Replace the cover. the ability of controlling non McIntosh Components in your system.
Page 4
Code Number Component Group steps 2 to 4 and try entering the code again. Cable (Cable Converter, Video Accessories, 5. Aim the McIntosh Remote Control at the compo- Satellite Receivers) nent and press Power Off. The TV should turn Off. If it does not, repeat steps 3–5, trying each VCR (VCRs, DVD Players) code for your brand until you find one that works.
Checking the Codes Programming a Learned Push-button Programming a Learned Key CHECKING THE CODES USING LEARNING NOTE: If more than 10 seconds pass between key If you have set up the remote using the procedure in This universal remote control includes a Learning presses, the remote exits programming.
Volume Lock Once you have completed learning all keys, press and CHANGING VOLUME LOCK 1. Press a device key (TV. VCR/DVD, CBL/ SAT, hold SETUP until The Potenza universal remote control comes preset to etc.). the LED blinks twice to save all data learned. allow independent 2.