Wah Maximum Frequency; Wah Sweep Type; Rotating Speaker Effect; Vibro Out Level - Fender CYBER-TWIN Instruction Manual

38
3 U H V H W ( G L W
Description
Adjustable parameters
®
1. C BS is a registered tradem ark of CB S Inc.
              
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
) ; 0 R G H
Minimum Frequency and Wah Maximum Frequency can "cross" one
another, such that the direction of drive for the wah can be reversed
(i.e., idle state is high frequency, playing louder drives the sweep to
lower frequency).
Wah Maximum Frequency. Adjusts the frequency the wah sweeps to

when your playing volume is at a maximum. Select between 1.0 for the
lowest frequency and 10.0 for the highest frequency.
Wah Sweep Type. Select between two wah types: Low Q and High Q. The

first selection is smoother and the second more extreme.
~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~
0 R G X O D W L R Q ( I I H F W V 7 \ S H V
9 L E U D W R Q H
Rotating speaker effect. Based on the CBS-era
was a cabinet equipped with a single speaker and a two-speed rotating
baffle.
Vibro Out Level. Adjusts the wet/dry signal ratio. Select between 1.0
/
for 0% wet (no effect) and 10.0 for 100% wet (all effect).
Rotor Speed (Hz). Range: 0.08 Hz to 10 Hz. Adjusts the rate of the

Vibratone effect. The increment of change gradually increases from
0.01 Hz for the slowest rate to 0.08 Hz for the fastest rate. Remember
that the TAP button can always be used to key in the rotor speed by
feel– two TAPs set the time it takes for the LFOs to go through one
cycle. Remember that although this is a stereo effect, both of the
voices move at the same rate.
Vibro Doppler. Adjusts the amount of Doppler shift and how apparent

the effect sounds. Select between 1.0 for no apparent effect and 10.0
for maximum effect. Rotor Speed 1 (Hz) &
Rotor Speed 2 (Hz).

Range: 0.08 Hz to 10 Hz. Select the two rotor speeds to alternate
between when using a footswitch (optional) connected at the REV/
BYPASS jack, (see item "FF) REVERB / EFFECTS BYPASS" on page
16 for details on connecting a footswitch).
Other requirements: First, select Vibratone as the active FX. Then
use the AMP key to access the Reverb/
the Vibro Fast/Slow value with the DATA WHEEL.
Now pressing the footswitch will alternate between the settings of
Rotor Speed 1 and Rotor Speed 2. The shift between rotor speeds is
gradual, as it takes a moment for the virtual baffles to gain (or lose)
momentum.
                             
1
Fender Vibratone, which
FX
Bypass menu item. Select
           & < % ( 5
FX
 7 : , 1