IKEA SODERBODA Manual page 8

8
Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
After starting a programme, it may take up to
5 minutes for the appliance to recharge the
resin in the water softener. It seems that the
appliance is not working.
The washing phase starts only after this
procedure is completed. The procedure is
repeated periodically.
The salt container
CAUTION!
dishwashers only. Fine salt increases the risk of
corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in daily
use.
Filling the salt container
Fill the salt only when the salt indicator (
turns on.
1
Find the salt container
at the bottom.
3
Use rough salt designed for
2
Remove the cap of the
salt container.
4
To download the full version visit www.ikea.com
Place the funnel (if
supplied) over the mouth
of the salt container,
then put 1.5 kg of
dishwasher salt in the
container.
5
Tightly close the cap of
the salt container.
CAUTION!
out of the salt container when you fill it. After
you fill the salt container, immediately start a
programme to prevent corrosion.
Filling the rinse aid dispenser
1
)
2
3
ENGLISH
Fill the salt container to
the maximum level with
water.
Water and salt may come
Find the rinse aid
dispenser on the inside
of the door.
Remove the rinse aid
reservoir cap by lifting
the handle.
Fill the rinse aid
container with rinse aid.
Be careful not to overfill.