1. Manuals
  2. Brands
  3. PRESIDENT Manuals
  4. Radio
  5. JOHNNY III
  6. Owner's manual

PRESIDENT JOHNNY III Owner's Manual

Automatic squelch control 12/24 v
Hide thumbs Also See for JOHNNY III:

Advertisement

Table of Contents

12/24 V
Owner's manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JOHNNY III and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for PRESIDENT JOHNNY III

Summary of Contents for PRESIDENT JOHNNY III

  • Page 1 12/24 V Owner’s manual...
  • Page 2 Your PRESIDENT JOHNNY III ASC 12/24 V at a glance...

  • Page 3: Installation

    Welcome to the world of the new generation of CB radios. The new PRESIDENT range gives you access to top performance CB equipment. With the use of up-to-date technology, which guarantees unprecedented quality, your PRESIDENT JOHNNY III ASC 12/24 V is a new step in personal communication and is the surest choice for the most demanding of professional CB radio users.

  • Page 4: Antenna Installation

    3) POWER CONNECTION a) Choosing your antenna Your PRESIDENT JOHNNY III ASC 12/24 V is protected against an inversion of polarities. However, before switching it on, you are advised to check all the connections. Your For CB radios, the longer the antenna, the better its results. Your dealer will be able equipment must be supplied with a continued current of 12 or 24 volts (A).

  • Page 5: For The First Time

    ASC: AUTOMATIC SQUELCH CONTROL Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Worldwide patent, a PRESIDENT exclusivity. b) To adjust the SWR meter: Turn the SQ knob (2) anti-clockwise into ASC position.
  • Page 6 3) DISPLAY Proceeding: switch off the transceiver. Keep the key F pressed and switch on again. and the letter corresponding to the configuration are blinking. It shows all functions: In order to change the configuration, use the channel selector on the front panel. When the configuration is selected, press 1 second on the F key.
  • Page 7 for an optimum transmission quality. Adjustable level from 1 (high level) to 9 (low There comes “Roger beep” from. corresponds to the Sensitivity Level. Note: the Roger beep also sounds in the loudspeaker if the KEY BP function is active. level) by rotating the channel knob.

  • Page 8: Technical Characteristics

    C) TECHNICAL CHARACTERISTICS 11) LOCK Allows to lock all the keys on the front panel and the rotary knob. An error beep 1) GENERAL sounds when a key is used and the LOCK function is activated. A short press on - Channels : 40 LOCK activates/deactivates the LOCK function.

  • Page 9: Troubleshooting

    D) TROUBLE SHOOTING your signal. Release the switch and wait for a reply. You should receive a reply like, «Strong and clear». If you use a calling channel (19, 27) and you have established communication with 1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR someone, it is common practice to choose another available channel so as not to TRANSMISSION IS OF POOR QUALITY block the calling channel.
  • Page 10 Down one : Go to a lower channel : High Frequency : Low Frequency Do you copy? : Understand? : Lower Side Band : Long distance : Receiver Eighty eights : Love and kisses : Single Side Band Eye ball : CBers meeting together : Standing Wave Ratio Good buddy...

Table of Contents