Key Automation RXM5A Instructions And Warnings For Installation And Use page 6

EN
If the deletion/reset has been successful, the
4
receiver will give one long flash
4.4 CHANGE MONOSTABLE/BISTABLE BEHAVIOR OF OUT2
For the second output, OUT2, it is possible to set monostable or bistable
operation.
PH. DESCRIPTION
Press and hold the receiver button until the
1 LED lights up (approximately 3 seconds) and
then turns off (3 seconds). Release the button.
About 1 second after releasing the button, the
2
LED on the receiver starts flashing.
To switch from monostable to bistable or vice
3 versa, press the receiver button at the seventh
flash.
If the output modification is successful, the
4
receiver will emit 1 long flash.
4.5 REMOTE MEMORISATION OF A REMOTE CONTROL WITH
A REMOTE CONTROL ALREADY MEMORISED
A transmitter can be memorised without accessing the receiver. The user
needs to have a transmitter memorised previously, after which the procedure
is as described below. The remote copy procedure must be carried out in the
area served by the receiver.
PH. DESCRIPTION
Press the key of the new remote control to be
1
memorised, holding it down for at least 5 seconds
Press the key of the old remote control to be
2 copied (if phase 1 has been successful, the
automation system will not respond)
Press the key of the new remote control to be
3
memorised, holding it down for at least 3 seconds
Press the key of the old remote control to be
4 copied, holding it down for at least 3 seconds, to
confirm and quit the programming mode
If no commands are given for 7 seconds, the
N.B. receiver automatically quits the programming
mode
6
EXAMPLE
( > 3s)- > ( > 3s)- >
(1s) + (1s)
EXAMPLE
> 5s
> 3s
> 3s
> 3s