Key Automation RXM5A Instructions And Warnings For Installation And Use page 5

The LED on the receiver will flash a number of
2 times equal to the number of the output selected,
with 1 second pauses between flashes
Press the key of the remote control to be
3 memorised within 7 seconds, holding it down for
at least 2 seconds
If the memorisation has been successful, the
4
receiver will give one long flash
To memorise another remote control on the same
5
output, repeat point 3
If no commands are given for 7 seconds, the
N.B. receiver automatically quits the programming
mode
4.2 DELETING A BUTTON FROM A REMOTE CONTROL
PH. DESCRIPTION
Press the button on the receiver until the LED
1
lights up (about 3 seconds)
Press the key of the remote control to be deleted
within 7 seconds, holding it down until the LED on
2
the receiver goes out. Release the remote control
key
About 1 second after the key is released, the LED
3
on the receiver starts to flash
Confirm the deletion by pressing the button on the
4
receiver
If the deletion of the button has been successful,
5
the receiver will give one long flash
If no commands are given for 7 seconds, the
N.B. receiver automatically quits the programming
mode
4.3 CLEARING THE ENTIRE RECEIVER MEMORY/ RECEIVER
RESET
PH. DESCRIPTION
Press the button on the receiver and hold it down
1 until the LED lights up (about 3 seconds) and then
goes out (about 3 seconds). Release the key
About 1 second after the key is released, the LED
2
on the receiver starts to flash
To clear the entire memory, press the receiver
button on the third flash, or to reset the 4 outputs
3
and restore the default monostable settings,
press the button on the fifth flash
+1s +1s
2s
3s
EXAMPLE
( > 3s)- >
- >
0,5s 0,5
3s
EXAMPLE
( > 3s)- > ( > 3s)- >
(1s) + (1s) +
EN
5