MYPV AC-THOR Instructions For Connecting

AC•THOR / AC•THOR 9s / AC ELWA 2
Default settings on the my-PV device
1.
Before commissioning, read the assembly instructions delivered with the device and the
operating instructions available online.
The AC•THOR operating instructions can be found
The AC ELWA 2 operating instructions can be found
Communication with Sigenergy
2.
The communication parameters are preset from AC•THOR firmware a0021900,
for AC ELWA 2 from firmware e001401.
AC•THOR or AC ELWA 2 are connected to the Sigenergy inverter in the network via a
router. Within this network, the device receives information from the Sigenergy inverter
about the available surplus photovoltaic energy.
Do not connect the device directly to the inverter or
•
battery system!
It is important that the IP address of the signal source
•
does not change during operation (e.g. due to a DHCP
router) when communicating with the device via the
network. Otherwise, the AC•THOR or the AC ELWA 2 will
lose the control signal.
AC•THOR or AC ELWA 2 with Sigenergy EN250306
Instructions for connecting
Sigenergy
to
here.
here.
1