How To Connect The Pc Input Terminals - BenQ Q150 User Manual

User manual
Table of Contents

Advertisement

D. How to connect the PC Input Terminals
RGB signal (min D-SUB 15 pin) connection
Example of input signal source
Note:
The display native resoluti on is 1024 x 768. If the signal resolution exceeds the native
1.
resolution, it may not be possible to show fine detail with sufficient clarity.
An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh
2.
computer to the set.
Some PC models cannot be connected to the set.
3.
There is no need to use an adapter for computers with DOS/V compatible D-sub 15P
4.
terminals.
D-sub supports PC and Component (Y Cb/Pb Cr/Pr) signal. Component video is the
5.
best type of signal that can be used. The most common sources that use Component
outputs are DVD players, and it is highly recommended that Component be used when
possible. Component video goes one step beyond S -Video in picture quality. All HDTV
signals must be input into this port. It may also be used for other high-resolution signals
such as progressive DVD players or computers.
We can support 480p, 720p and 1080i HDTV signal.
6.
D-sub supports Component (Y Cb/Pb Cr/Pr) signal in TV/AV mode. It is normal to
7.
display green page on the screen when choose PC mode in Component (Y Cb/Pb
Cr/Pr) signal connection.
8. The computer shown in the illustration is for example purposes only.
9. Additional equipment and cables shown are not supplied with this set
10. Do not set the horizontal and vertical scanning frequencies for PC signals, which are
above or below the specified frequency range.
11. For more information about external device connections, see the manuals of your
external devices.
Connect the D -sub signal terminal on the TV
to the output of PC equipment through min D-
sub 15 pin cable as illustrated.
Connect a cable, which matches the audio
output terminal on the computer.
This D-sub signal terminal also support
Component (Y Cb/Pb Cr/Pr) Signal. Please
connect D-sub terminal on the TV to the signal
output of AV equipment through D-sub to
component cable.
User's manual
Connections 21

Advertisement

Table of Contents
loading

Table of Contents