codec (dial-peer)
codec (dial-peer)
To specify the voice codec for a network dial peer, enter the codec dial-peer configuration command.
Use the no form of this command to restore the default value.
codec
Syntax Description
bytes
payload-size
Defaults
If no codec is specified, dial peers are configured for g729r8 and the voice payload is as shown in Table 3
for G.729r8.
If a codec is specified without the bytes keyword, the voice payload is as shown in Table 3.
Command Modes
Dial-peer configuration
Cisco IOS Release 12.1(2)T
8
Configuring Cisco MC3810 Series Concentrators to Use High-Performance Compression Modules
codec codec [bytes payload-size]
no codec
Codec options on Cisco MC3810 series equipped with HCM, and with codec
complexity set to high or medium:
g711alaw—G.711 A Law, 64000 bps
•
g711ulaw—G.711 u Law, 64000 bps
•
g723ar53—G.723.1 Annex A, 5300 bps
•
g723ar63
•
g723r53—G.723.1, 5300 bps
•
•
g723r63—G.723.1, 6300 bps
•
g726r16—G.726, 16000 bps
•
g726r24—G.726, 24000 bps
g726r32—G.726, 32000 bps
•
g728
•
g729abr8—G.729 Annex A and Annex B, 8000 bps
•
g729ar8—G.729 Annex A, 8000 bps
•
g729br8—G.729 Annex B, 8000 bps
•
g729r8—G.729, 8000 bps
•
(Optional) The voice payload for each frame.
(Optional) Number of bytes you specify as the voice payload of each frame.
Values depend on the codec type and the packet voice protocol. See Table 3 for
valid entries and default values.
—G.723.1 Annex A, 6300 bps
—G.728, 16000 bps