Advertisement
Configuring Cisco MC3810 Series Concentrators to Use High-Performance Compression Modules
Specifying Codecs for Network Dial Peers
Follow these steps to specify a codec for each network dial peer according to the codec complexity
setting selected for this Cisco MC3810. If you do not set codec complexity and specify a codec, the
defaults remain in effect: medium complexity and G.729, 8000 bps.
This does not cover the complete dial-peer configuration procedure. To learn more, see the Cisco IOS
Multiservice Applications Configuration Guide and the Cisco IOS Multiservice Applications Command
Reference for Cisco IOS Release 12.1.
Command
Step 1
Router# configure terminal
Step 2
Router(config)# dial-peer voice tag
}
voatm
Step 3
Router(config-dial-peer)# codec codec
]
payload-size
Step 4
Router(config-dial-peer)# exit
Verifying Network Dial Peers
Follow the procedure below to verify dial-peer configuration. To learn more about these commands, see
the Cisco IOS Multiservice Applications Configuration Guide and the Cisco IOS Multiservice
Applications Command Reference for Cisco IOS Release 12.1.
Enter the privileged EXEC show dial-peer voice command. The following text is sample output from
the show dial-peer voice command for a VoIP dial peer:
Router# show dial-peer voice 10
VoiceOverIpPeer10
{
|
voip
[
bytes
information type = voice,
tag = 10, destination-pattern = `555....',
answer-address = `', preference=0,
group = 10, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
application associated:
type = voip, session-target = `ipv4:10.1.1.1',
Purpose
Enter global configuration mode.
|
Enter dial-peer configuration mode and specify a
vofr
network dial peer for which to specify a codec.
tag is one or more digits to identify the dial peer. Valid
entries are 1 to 2147483647.
Specify a codec for the dial peer. Codec types are as
follows:
g711alaw, g711ulaw,
g723ar53, g723ar63, g723r53, g723r63,
g726r16, g726r24, g726r32,
g728,
g729abr8, g729ar8, g729br8, g729r8
The default is g729r8.
Optionally specify the voice payload (in bytes) of each
frame.
For information about the options available for the
codec command, see the command reference section or
enter ?.
Exit from dial-peer configuration mode.
Configuration Tasks
Cisco IOS Release 12.1(2)T
5
Advertisement
