EHEIM 160, 200, 240, 2411, 2412, 2413 Manual

Symbol explanation

The following symbols are used on the appliance:

	The appliance must only be used indoors, and exclusively for aquariums.
	The appliance is of protection class II.
	The symbol indicates that the appliance is protected against permanent submerging.
	The appliance is certified according to the relevant national regulations and directives, and conforms to EU standards.

The following symbols and signal words are used in this operating manual:

The symbol indicates imminent danger from electric shock that can result in death or serious injury.

The symbol indicates imminent danger that can result in death or serious injury.

The symbol indicates imminent danger that can result in moderate to minor injury or a health risk.

The symbol indicates the danger of material damage.
Note with useful information and tips.

Function

1. Diffuser with hose and air regulating valve
2. Nozzle tube
3. Power regulator
4. Pump head
5. Shaft with bushings
6. Impeller
7. Pump cover
8. Holder with suction cups
9. Pump head holding fixture
10. Cover grate
11. Fine filter cartridge
12. Prefilter cartridge
13. Filter canister
14. Filter base
15. Clip.

In a single operation, this modular internal filter ensures the mechanical-biological cleaning of the aquarium water with permanent circulation, specific surface movement and controllable oxygen supply.
Thanks to the pump head that rotates in three dimensions, it is possible to adjust the outflow direction. The output regulator determines the desired flow rate and the air enrichment can be regulated using the diffusor or nozzle tube.
In the filter containers, foamed material cartridges provide for mechanical cleaning and EHEIM SUBSTRAT pro for efficient biological water purification.
The practical holder allows the filter to be positioned inside the aquarium and removed with ease.

Installation/Putting into operation

Attach diffuser with air hose and air regulating valve or place nozzle tube on outlet connection.

Fasten the holder with the suction cups to the inside of the aquarium glass and cli the filter into place.

Insert the filter such that the pump head is positioned just beneath the surface of the water (approx. 1 cm). Adjust the pump head to the required outflow area and surface angle.

By turning the power regulator, it is possible to infinitely adjust the pump power to the required setting. The diffuser's air regulating valve is used to regulate the amount of oxygen added to the water.

The diffuser power decreases in line with the degree of soiling.

Cleaning

Disconnect the filter from the power supply and then pull upwards out of the holder.

The individual filter containers can be easily separated from one another by a slight pressure on the clip.

Then clean the modules and wash out the prefilter cartridge. Only rinse off slightly the EHEIM SUBSTRATpro biological filtering material under lukewarm water so as to preserve the bacterial lawn and accelerate redevelopment of it.

Pull the edge provided the cover grate out of the pump head retainer. Wash out or replace the fine filter cartridge. Finish by reassembling the cleaned filter components, taking care to assemble these in the correct way.

Do not overfill filter inserts as, otherwise, their accurate fit is no longer assured.

Maintenance

Disconnect the filter from the power supply! To remove the pump head, pull the pump out of the pump head socket.

Remove the pump cover, take out the impeller and the bearing box and clean. Pull out the power regulator with diffuser/nozzle tube from pump head. Use the special cleaning brush (order no. 4009560) to clean the inflow and outflow openings.
Subsequently, refit the impeller and check that the bearing box is positioned correctly. Close the pump cover and reinsert the pump head.

Accessories

1. Via the filter container, the interior filter can be used for targeted water treatment and filled with other original EHEIM filtering materials as required.
2. 1. 2 filter cartridges (no. 2618060)
   2. 2 activate carbon cartridges (no. 2628080)
3. 2 filter cartridges (no. 2618080)
4. 1. Wide-jet pipe (no. 4009680)
   2. Nozzle set (no. 4009700)
5. Extension SET 2 (no. 4009620)

Storage

1. Take the appliance out of the aquarium.
2. Clean the appliance
3. Store the appliance in a frost-proof place.

VERY IMPORTANT SAFETY INSTRUCTIONS

To guard against injury, basic safety precautions should be observed, including the following.

• FOR HOUSEHOLD USE ONLY
  
  RISK OF ELECTRIC SHOCK!
• This pump has not been investigated for use in swimming pools areas!
• DO NOT RUN DRY!

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

• 
  To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance to an authorized service facility for service or discard the appliance.
• If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source.
• Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
• Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped or damaged in any manner.
• To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium stand and tank to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or plug. A "drip loop", shown in the figure, should be arranged by the user for each cord connecting the aquarium appliance to a receptacle. The "drip loop" is that part of the cord below the level of the cord and coming in contact with the receptacle. If the plug or receptacle does get wet, DON'T unplug the cord; disconnect the fuse or circuit breaker that supplies power to the appliance. Then unplug and examine for presence of water in the receptacle.
  
• Close supervision is necessary when any appliance is used by or near children.
• To avoid injury, do not contact moving parts.
• Always unplug an appliance from an outlet when not in use, before putting or taking off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
• Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
• Do not install or store the appliance where it will be exposed to the weath peratures below freezing.
• Make sure an appliance mounted on a tank is securely installed before operating it.
• Read and observe all the important notices on the appliance and its cord.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
• Check that the voltage shown on the label of the unit corresponds to the voltage of the mains supply.
• Disconnect all electrical appliances from the mains before placing hands in the water.
• The line cord of this unit cannot be replaced or repaired. Should the line cord become damaged the appliance must be discarded.

The appliance and all parts included in the scope of delivery are intended for private use and must only be used:

• For the cleaning of aquarium water in fresh and salt water aquariums.
• indoors
• in compliance with the technical data

The following limitations apply to the appliance:

• do not use for commercial or industrial purposes
• the water temperature may not exceed 35°C
• Corrosive, highly flammable, aggressive or explosive substances, foodstuffs and drinking water must not be conveyed.
• never operate without a water flow.

Safety instructions

Risks for persons and property can arise from this appliance if the appliance is improperly used or not used as intended or if the safety instructions are not heeded.

For your safety

• Do not let the appliance packaging and small parts get into the hands of children or people who are unaware of how to handle them, as hazards can arise (danger of suffocation!). Keep away from animals.
• Only for EU countries:
  This appliance can be used by children from the age of 3 and by persons with reduced physical, sensory or mental capabilities or lack of experience and/or knowledge if they are supervised and have been instructed in the safe use of the appliance and have understood the resulting dangers. Children must not play with the appliance. Cleaning and user maintenance must not be carried out by children unless they are supervised.
• This equipment is not intended for use by persons (including children) with limited physical, sensory or mental abilities or for persons with no experience or knowledge unless they are supervised by a person respond for safety or unless they have received from such a person instructions on how to use the equipment. Children should be supervised to ensure that they do not play with the equipment.
• Before use, carry out a visual inspection to ensure that the appliance, especially the mains cable and plug, are undamaged.
• Do not use the device if it does not function properly or if it is damaged.
• Never use the appliance with a damaged mains cable or power supply unit.
• The power cable of this device can not be replaced. When the line is damaged, the device must no longer be used.
• Repairs must only be carried out by an EHEIM service centre.
• Do not carry the appliance by the mains cable, and to disconnect from the mains, always pull on the plug and not on the cable or appliance.
• Protect the mains cable against heat, oil and sharp edges.
• Only carry out the work described in these instructions.
• Never make technical modifications to the appliance.
• Only use original spare parts and accessories for the appliance.

• The device should be protected by means of a residual current protective device with a maximum rated residual current of 30 mA. Ask your electrician.
• If they are not being used, always disconnect all devices in the aquarium from the power supply before you install/remove any parts and before all cleaning and maintenance work.
• Protect the mains socket and mains plug against moisture. It is recommended to form a drip loop.