Advertisement
Table 3 - Switches 1 - 4: Start/End Transmission speed in G3 mode
The starting and ending transmission speed can be set separately in
G3 overseas communication mode. If there is excessive noise,
decrease the starting Speed.
transmission of the document takes too long. These settings are
independent of the overseas communications mode (Table 2 switches 2
and 3).
Table 4 - Switches 3 & 4: Modem Equalizer
These switches are uSed for setting the Modem Equalizer to
compensate for line loss. m8 function section of Table 4 lists the
relationship between the line loss and the appropriate switch setting
that compensates for that loss.
Table 4 - Switches 5- 8: Modem Attenuator
These switches are used to adjust the transmission level attenuation.
The amount of attenuation is accumulative when setting more than one
switch to "1". For example, if switches 5 and 6 are set to "1" and
switches 7 and 8 are set to "O", the accumulative attenuation is 12 dB.
maximum attenuation with all the switches set to "1' is 15 dB.
When a switch in this section of table 4 is set to '0" that switch value
is 0 dB.
SECOND LEVEL SOFT SWITCH DATA PRINTOUT
Operation Method
1. To print the "SYSTEM CONFIGUBATION LIST" which contains the
Second Level Soft Switch Data, 8nt8r th8 initial maintenance mode.
Press the "1" key twice. Th8 LCD will continue to display
"MAINTENANCE" and the 'SYSTEM CONFIGURATION LlSP will be
printed.
2. Upon completion of printing the "SYSTEM CONFIGURATION UST', the
unit will emit one long beep indicating it has rstumed to the initial
maintenance mode.
PSB No: P- 0070
Page: 5 of 8
Advertisement
