Battery Main Switch - Mercedes-Benz Sprinter 2021 Operating Instructions Manual

130 Driving and parking
130
exhaust gases can occur in the vehicle sur-
roundings. Con rm for three seconds with OK.
Regeneration starts. The engine speed increa-
ses and the message
appears.
%
The duration of regeneration depends on the
load condition of the diesel particulate lter
(approx. 20‑25 minutes).
A er successful regeneration, the engine
speed is reduced again.
T T o cancel r o cancel reg egener eneration: ation: Switch o the vehicle
#
or depress the clutch (for manual transmission)
or brake (for automatic transmission).
Regeneration is cancelled.
Regeneration cannot be requested again until the
load condition of the diesel particulate lter is at
least 100%.
Displa Displaying t ying the load he load
On-board computer:
Service Consumption info
4 5
The load of the diesel particulate lter is displayed.
Load display at 75% load
T T o e o exit t xit the display he display: : press the back button on
#
the le -hand side of the steering wheel.
Bear in mind the following related topic:
Operating the on-board com-
R
puter( page 181)
/
Batt Batter ery main switch y main switch
N N o o t t es on t es on the batt he batter ery main switch y main switch
* N N O O TE TE Damaged to control units and
cooled component parts
When the main battery switch is removed
immediately, cooling of important component
parts and the storage of parameters in the
control units can be interrupted. This can sig-
Regeneration active
ni cantly reduce the service life of component
parts and control units.
Make sure that vehicle is switched o .
#
Then wait at least 20 minutes before
removing the battery main switch.
You can use the battery main switch to disconnect
the current to all your vehicle's consumers. This
will prevent uncontrolled battery discharge caused
by quiescent current consumers.
If your vehicle is equipped with an auxiliary battery
in the engine compartment or in the base of the
co-driver seat, you must disconnect both batteries.
Only then is the electrical system fully disconnec-
ted from the power supply.
%
Only disconnect the vehicle from the power
supply using the battery main switch in the fol-
lowing situations:
the vehicle is stationary for a long time
R
it is absolutely necessary to disconnect
R
the vehicle from the power supply
A er switching on the power supply, you will
need to reset the side windows (
and the electric sliding door (
%
A break in the power supply is entered in the
DTCO (digital tachograph) as an event in the
fault memory.
See the separate DTCO operating instructions.
Switching t Switc hing the pow he power suppl er supply y on/o
Switc Switching hing o o t t he pow he power supply er supply

Battery main switch

page 65)
/
page 59).
/
on/o