SECOLink PAS8 Series Wiring Manual page 6

Intruder alarm system
Maintained Key-switch zone wiring
(for PAS816, PAS832)
Wiring:
PAS8xx or module
NO
NC
Z8 COM
Crosses and dashed lines shows the commonly used locations of the modules. The circuit board mounting holes of wireless zone expanders EXT016,
EXT216 or EXT116S matches with mounting holes of EXM800, however it is recommended to install these modules outside the metal cabinet. The special
plastic housing is designed for these modules.
Installation of control panel, zone/PGM expansion and LAN modules
EXM800
PAS808M, PAS816, PAS832
Page 6
Wiring samples (continued)
Programming (using MASCAD):
Installation of modules in CAS8 metal cabinet
EXM800 EXM800
LAN800
Installation of extra power supply module and zone/PGM expansion
PWR20
EXM800
Momentary Key-switch zone wiring
Wiring:
PAS8xx or module
NO
NC
Z8 COM
Installation of control panel, zone/PGM expansion and GSM/GPRS
PAS808M, PAS816,
EXM800
modules
EXM800
EXM800 EXM800
Control Panels PAS8xx
(for PAS816, PAS832)
Programming (MASCAD):
module or LAN modules
GSV6 or
PAS832
LAN800
EXM800 EXM800
Wiring manual