Registering Bluetooth Unit - Kenwood DNX5140 - Wide Double-DIN In-Dash Nagivation Instruction Manual

Setup Menu

Registering Bluetooth Unit

Registers the Bluetooth unit to be connected.
1 Display the Connect Device List screen
2 Search for a Bluetooth unit
1
1 Displays the registered Bluetooth unit.
Displays the busy service in red. Displays
the available service in gray.
2 Scrolls the name of the Bluetooth unit.
3 Searches for Bluetooth unit.
4 Registers Bluetooth unit that cannot be
registered by normal register (paring)
operation.
5 Returns to the previous screen.
⁄
• A new device cannot be registered if there are 5
registered Bluetooth units. Delete unnecessary
registration. See <Deleting Bluetooth Unit> (page 82).
3 Select the Bluetooth unit to register
6
10
10
6 Displays the searched Bluetooth unit.
7 Scrolls the name of the Bluetooth unit.
8 Cancels searching of Bluetooth unit.
9 Starts search.
p Scrolls.
q Returns to the previous screen.
DNX6140/DNX6000EX/DNX5140/DDX514/DDX5034/DDX5034BT
80
4 Enter PIN code
Enter the PIN code specified for the Bluetooth
unit to register.
w Enters a code number.
e Cancels registration of PIN code.
r Enters PIN code.
t Clears the code number.
2
⁄
3
• You can also register from the Bluetooth unit side. For
the PIN code necessary for registration, see <Registering
4
Bluetooth Unit PIN Code> (page 81).
5
• If the error message appears even though the PIN code
is correct, try <Registering Special Bluetooth Unit> (page
81).
7 8
9
11
12
13
14
15