Installing The Removable Faceplate - Phase Linear UMP401 - Radio Owner's Manual

INSTALLING THE REMOVABLE FACEPLATE

Faceplate Installation
To install the faceplate, slip the right edge of the
front panel into the radio then gently press the
left side into place.
Faceplate Detachment
To remove the faceplate, press the release
button, and pull gently on the left side of the
front panel.
For safekeeping, store the front panel in the
protective case provided.
Handling Precautions
• Make sure the front panel is right-side-up
when attaching it to the chassis as it cannot
be attached when up-side down.
• Do not press very hard on the front panel
when attaching it to the chassis. No more
than light to moderate pressure is needed.
• When attaching the front panel, make sure it
is centered in the chassis frame and is
pressed straight into position.
• Do not drop the front panel.
• Do not put pressure on the display or control
buttons when handling the front panel.
• Do not touch the electrical terminals on the
front panel or main unit.
• Remove dirt or foreign substances with a
clean, dry cloth only.
• Do not expose the front panel to extreme
temperatures or direct sunlight.
• Keep volatile agents such as benzene,
thinner or insecticides away from the front
panel.
• Do not disassemble the front panel.
• When taking the front panel with you, please
use the supplied carrying case to protect the
panel from dirt and damage.
6
E R
C E IV
/ R E
M A
3 / W
M P
D / /M O
1 C S T
P 4 0
U M
6
D O M
R A N
5
T E E A T
M U R E P 4
C C
S R S R IN T R O
3
2
1
/P S
S E L S E L
A S
P
D IS
• Make sure there is no dust or dirt on the
electrical terminals on the back of the panel
as this could cause intermittent operation or
other malfunctions.
UMP401
N D
B A
D
L O U
/D X
L O