Order of files
Files are played back in the order that the writing software writes them
to the disc. Therefore, the playback order may not be what is expected.
Verify the writing order in the software's documentation. The playback
order of the folders and files is as follows.
Root folder
Folder
The folder No./ folder Name will not be displayed if no readable file is
contained in the folder.
Terminology
Bit rate
This is the "sound" compression rate specified for encoding. The higher
the bit rate, the higher the sound quality, but also the larger the files.
Sampling rate
This value shows how many times per second the data is sampled
(recorded). For example, music CDs use a sampling rate of 44.1 kHz, so
the sound is sampled (recorded) 44,100 times per second. The higher
the sampling rate, the higher the sound quality, but also the larger the
volume of data.
Encoding
Converting music CDs, WAVE (AIFF) files, and other sound files into the
specified audio compression format.
Tag
Song information such as track titles, artist names, album names, etc.,
written into MP3 files.
Root folder
The root folder (or root directory) is found at the top of the file system.
The root folder contains all folders and files. It is created automatically
for all burned discs.
14
-EN
MP3 File
Sound Setting
AUDIO/SETUP
Rotary encoder/
Adjusting Subwoofer Level/Bass Level/Mid
Level/Treble Level/Balance (Between Left
and Right)/Fader (Between Front and Rear)/
Loudness/Defeat
1
Press AUDIO repeatedly to choose the desired mode.
Each press changes the mode as follows:
*1
*2
*2
BASS
MID
SUBW
DEFEAT VOLUME SUBW
When the subwoofer mode is set to OFF, its level cannot be
adjusted, refer to "Turning Subwoofer ON/OFF" on page 16.
Adjustable only when DEFEAT is OFF.
Subwoofer
Bass level
Mid level
Treble level
Balance
Fader
Loudness
Defeat
Volume
Notes
• If no operation is performed for 5 seconds, the unit automatically
returns to normal mode.
• Loudness introduces a special low- and high-frequency emphasis at low
listening levels. This compensates for the ear's decreased sensitivity to
bass and treble sound.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted level settings of
BASS, MID, and TREBLE will return to the factory defaults.
Sound Setting
You can flexibly customize the unit to suit your own preference and
usage. From the AUDIO SETUP menu, Audio Setting can be modified.
Use steps 1 to 5 to select the category you wish to modify. For
details on how to change each setting, see the following sec-
tions below.
/ENTER
*2
TREBLE
BAL FAD LOUD
0 ~ +15
-7 ~ +7
-7 ~ +7
-7 ~ +7
L15 ~ R15
R15 ~ F15
ON/OFF
ON/OFF
0 ~ 35
*2