Device Selection; Side Panel - Denon DN-HC5000 - Serato ITCH Hardware/Software Package Operating Instructions Manual

ENGLISH

3. Device Selection

PARAMETERS knob
ITCH/CD for DECK1 ITCH/CD for DECK2
• Press the ITCH/CD button for
Deck A or Deck B (the side
whose device you want to
switch) to display the source
selection screen.
Display when ITCH is connected
Display when CD is connected
Note:
• Press the BACK button to return to the normal
mode.
• Press the PARAMETERS knob
to complete device selection.
Display when ITCH is connected
Display when CD is connected
Note:
• Turn the PARAMETERS knob to switch the
display. Press the PARAMETERS knob or BACK
button while the message below is displayed to
return to the normal mode.

4. Side Panel

q LINE OUT 1/2 terminals
• This is unbalanced RCA output terminals.
• Audio signals outputs.
w DRIVE terminal
• Connect the DN-D4000/D4500/BU4500 drive
unit.
For instructions on operating the DN-D4000/
D4500/BU4500, refer to the respective
model's operating instructions.
e USB B terminal
• Connect to a computer.
• Sends the control commands from the DN-
HC5000.
• Sends the USB audio signals from a PC.

ENGLISH
u y
q w e r t
r POWER ON/OFF button
• Press this button to turn power on and off.
t AC IN terminal
• Inlet the power cord's plug into DN-HC5000's
AC inlet terminal.
y FADER 1/2 terminals
• Use this when your mixer has the Fader Start
function.
u X-CONTROL terminal
• Use this when connected to a DENON
DN-X900 or DN-X500 mixer that offers X-
Control.
• With the DN-HC5000 it is possible to convert
the input fader position into a control signal.